Caravan Control Unit Configuration Of Analog Outputs, Function - GF54.21-D-5021TSA

Model 907 

with code JA3 (Intelligent body control.) 

General 

Analog outputs are used to set voltage values to, e.g. actuate a device that - depending on the voltage applied to its input - executes specific actions.

The MB Advanced Control control unit (N175) can operate 5 analog outputs.

The MBAC consists of two stages, MBAC Stage I and MBAC Stage II.

The MBAC is designed to enable configuration of the assignment of the I/O interfaces. The assignment of the I/O interfaces is configured by the body manufacturer.

Assignment of I/O interfaces with analog outputs (example) 

Each stage has exactly one analog output "AO_Heating_Temperature_Actual_Value".

Each stage has exactly one analog output "AO_Heating_Temperature_Specified_Value".