Remove/Install Sliding Door Center Carriage - AR72.16-S-2230E

Model 447, 448 

Shown On Model 447.8 With Code T55 (Electrical actuation for right sliding door) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1.1	Remove electrical fuse 74 on left electric sliding door (4)	Model 447.7/8, 448 with code T56 (Electric operation of sliding door on left)
	Assignment of right footwell firewall fuse and relay module		GF54.15-S-1256-39TRA
1.2	Remove electrical fuse 311 on right electric sliding door (4)	Model 447.7/8, 448 with code T55 (Electric operation of sliding door on right)
	Assignment of fuse and relay module, right A-pillar		GF54.15-S-1256-38TRA
2	Remove left and right tail lamp		AR82.10-S-4905E
3	Remove center guide rail paneling for sliding door (4)		AR72.16-S-1260-01E
4	Remove transfer roller housing	Model 447.7/8, 448.8 with code T56 (Electric operation of sliding door on left) Model 447.7/8, 448 with code T55 (Electric operation of sliding door on right)	AR72.16-S-7820E
5	Remove screw/bolts (1)	Secure sliding door (4) against falling down. Otherwise the sliding door (4) can be damaged. Tighten bolts (1) with torque only after adjusting sliding door (4).
6	Remove sliding carriage (3) in direction of arrow	Carefully remove carriage (3). Otherwise the paint can be damaged.
7	Remove ball heads (2) from sliding carriage (3)	Model 447.7/8, 448.8 with code T56 (Electric operation of sliding door on left) Model 447.7/8, 448 with code T55 (Electric operation of sliding door on right) Carefully remove ball heads (2) from carriage (3). Otherwise the paint can be damaged.
8	Install in the reverse order.
	Adjust
9	Adjust sliding door (4)		AR72.16-S-1023E
	Check
10	Check sliding door (4) for proper function