Remove/Install Bottom Guide Rail For Sliding Door - AR72.16-S-7816E

Model 447, 448 

Shown On Model 447.8 With Code T55 (Electrical actuation for right sliding door) 

Courtesy of MERCEDES-BENZ USA

Shown On Model 447.8 With Code T55 (Electrical actuation for right sliding door) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Notice	General information on vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system as well as personal protective equipment	Model 447 with engine 780	AH00.00-Z-0300-01A
	Remove/install
1	Remove left or right underfloor trim.	Model 447 with engine 254 with code HX1 (Refrigerant R-1234yf) Model 447 with engine 654.9 Model 447.### ## up to 048754 with engine 651 with code MX0 (BlueEFFICIENCY package) Model 447.8## ## as of 048755 with engine 651 with code MX0 (BlueEFFICIENCY package) with code VQ1 (AVANTGARDE)	AR61.30-S-1001E
2	Remove the door sill panel on the left/right sliding door.		AR68.30-S-1312E
3	Remove the left/right running board.	Model 447, 448 with energy chain	AR88.30-S-2400E
4	Remove the holder for the electrical connectors (1) from the body.	Model 447, 448 with energy chain
5	Disconnect electrical connectors (1).	Model 447, 448 with energy chain The number of electrical connectors (1) varies depending on equipment installed.
6	Remove screws (2).
7	Unscrew screw (4).	Model 447, 448 with energy chain
8	Move the carrier (3) in the direction of the arrow and remove upward.	Model 447, 448 with energy chain
9	Remove the lower carriage for the sliding door.		AR72.16-S-7844E
10	Remove high-voltage battery.	Model 447 with engine 780.702/705	AR47.70-S-0002G
11	Remove the nuts (5) on the underbody.	Bolt/nut, sliding door guide rail to rocker panel	*BA72.16-Z-1014-01KOJ
12	Remove screws (6).	Bolt/nut, sliding door guide rail to rocker panel	*BA72.16-Z-1014-01KOJ
13	Remove screws (7).	Model 447.6 Model 447.7 except code T14 (Active lock, load compartment sliding door)
14	Mask entry in working area with adhesive tape.
15	Remove the guide rail (8).
16	Install in the reverse order.
	Check
17	Check the sliding door to ensure that it functions properly.