Code Parktronic (PTS) Control Unit - SM54.65-S-0002A

Model 447.### ## as of 000491 up to 004292

with CODE EZ7 (Active Park Assist)

with CODE RK1 (Tires 245/45 R19)

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	02 8630	Perform SCN coding in Parking Assist control unit		40 922 51	VS20SWFELG

	Check
1	Check whether vehicle is affected by measure
	Perform SCN coding
2	Connect diagnostic equipment
	Connect STAR DIAGNOSIS and read out fault memory	Use XENTRY Diagnostics - Version 07/14 with all relevant and updated add-ons or a higher XENTRY Diagnostics version. The operation steps must be performed exactly as per Xentry Diagnostics. If Xentry Diagnostics is already connected to the vehicle, continue with operation step 3.	AD00.00-S-2000-04E
3	Connect battery charger
	Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle	During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system. Otherwise any undervoltage that occurs may damage the control units. Use the charger to ensure that an adequate power supply (min. 12.5 V) is provided for the on-board electrical system battery.	AR54.10-S-1127E
4	Perform SCN coding of PARKTRONIC (PTS) control unit (N62)
	SCAN coding of control units	To do this, select menu item Control unit selection Information and communication PTS - PARKTRONIC (N62) Adaptations Configuration SCN SCN coding	AR54.21-S-0015E
5	Disconnect diagnostic equipment
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-S-2000-04E
6	Disconnect battery charger
	Maintaining on-board electrical system voltage when performing test and diagnosis work on vehicle		AR54.10-S-1127E