SCN Coding Of Control Units - AR54.21-S-0015E
Model 415, 447, 448
| Notes on programming control units | AH54.21-P-0001-03Z | ||
| Notes on SCN coding of control units | AH54.21-P-0004-01X | ||
| SCN coding | |||
| 1 | Connect diagnostic system and start "Xentry Diagnostics" (XD) | ||
| Model 415 | AD00.00-S-2000-04C | ||
| Model 447, 448 During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system. Otherwise any undervoltage that occurs may damage the control units. |
AD00.00-S-2000-04E | ||
| If the power supply of the on-board electrical system as supplied by the on-board electrical system battery is too low. ↓ Connect battery charger Model 447, 448 |
AR54.10-S-1127E | ||
| 2 | Perform SCN coding | ||
| 3 | Read out and erase fault memory | ||
| 4 | Disconnect diagnostic system | ||
| Model 415 | AD00.00-S-2000-04C | ||
| Model 447, 448 | AD00.00-S-2000-04E |