Establish Preconditions And Perform Checks For Wheel Alignment Measurement - AR40.20-P-0304-01MFA

Model 118, 177, 243, 247 

		Assign suspension data Model 243	AR40.20-P-0203QA
		Assign suspension data Model 247	AR40.20-P-0203MB
		Assign suspension data Model 177	AR40.20-P-0203MFA
		Assign suspension data Model 118	AR40.20-P-0203MFI
	Check tires for damage and crack formations	Model 243	AP40.10-P-4051EQ
	Check tires for damage and crack formations	Model 118, 177, 247	AP40.10-P-4051EW
	Correct tire pressure	Model 243	AP40.15-P-4061EQ
	Correct tire pressure	Model 118, 177, 247	AP40.15-P-4061A
	Check vehicle underside in visible area for signs of damage, fluid loss and corrosion	Model 243	AP60.00-P-0051O
	Check vehicle underside in visible area for signs of damage, fluid loss and corrosion	Model 118, 177, 247	AP60.00-P-0051M
		Raise/lower vehicle with vehicle lift	AR00.60-P-1006A
	Check condition of steering and tie rods	Model 243	AP46.00-P-4651I
	Check condition of steering and tie rods	Model 118, 177, 247	AP46.00-P-4651G
	Check condition of front axle and front axle ball joints	Model 243	AP33.10-P-3358J
	Check condition of front axle and front axle ball joints	Model 118, 177, 247	AP33.10-P-3358G
	Check condition of rear axle and rear axle ball joints	Model 243	AP35.20-P-3552K
	Check condition of rear axle and rear axle ball joints	Model 177, 247 with code U54 (Compound-link axle) except code U55 (Multi-link axle)	AP35.20-P-3552G
	Check condition of rear axle and rear axle ball joints	Model 118, 177, 247 with code U55 (Multi-link axle) except code U54 (Compound-link axle)	AP35.20-P-3552H
	Check condition of suspension struts or shock absorbers and springs	Model 243	AP32.25-P-3255M
	Check condition of suspension struts or shock absorbers and springs	Model 118, 177, 247	AP32.25-P-3255P

Check 

1. Check condition of vehicle.

   For the wheel alignment check all vehicle parts must be installed and the vehicle build completed ready to drive. Do not load the vehicle. The specified values for the vehicle are provided based on the actual values determined by the dimensional check system. The specified tolerances of vehicle specified values are only for the test. If the vehicle is adjusted, the specified values should be aimed for.

2. Print out form for wheel alignment measurement.

   If a visual wheel alignment measurement is performed.

3. Check tires for wear pattern, tire tread depth and damage.
4. Check rims for damage.
5. Check tire pressure.

   If necessary, Correct tire inflation pressure.

6. Check vehicle underside for damage, corrosion of suspension parts, chassis parts and supporting body parts, leaks from major assemblies and lines.
7. Raise front axle and check wheel bearing play without dial indicator.
8. Check condition of the steering mechanism.
9. Check front axle joints for play and check dust boots for damage.
10. Check rear axle joints for play and check dust boots for damage.
11. Check condition of shock absorbers and springs.