Section 291 (Overall Vehicle - 253 Chassis 5 Of 9)
WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.
- Safety Precautions
- Risk Of Injury Caused By Pinching Or Crushing When Working On Springs Or Spring Bodies That Are Under Tension - AS00.00-Z-0001-01A
- Risk Of Injury Caused By Burns To Skin And Eyes, Risk Of Poisoning Caused By Inhaling Vapors When Working With Plastics - AS00.00-Z-0001-02A
- Risk Of Injury. Skin Or Eye Injuries May Result When Handling Hot Or Glowing Objects - AS00.00-Z-0002-01A
- Risk Of Death. Death May Occur If Body Parts Are Drawn Into Rotating Vehicle Parts - AS00.00-Z-0004-01A
- Risk Of Accident From Vehicle Starting Off By Itself When Engine Running. Risk Of Injury (Bruises And Burns) Resulting From Working On The Engine While It Is Being Started Or When It Is Running - AS00.00-Z-0005-01A
- Risk Of Injury Caused By Drilling Gas-Filled Assemblies Or Components (Noncombustible Gases) - AS00.00-Z-0006-01A
- The High Voltage Used For Electric Welding Presents A Lethal Hazard. Risk Of Explosion From Welding In Areas Close To Highly Inflammable Materials. Risk Of Injury From Weld Splatter And UV-Light When Welding. Risk Of Poisoning From Inhaling - AS00.00-Z-0007-01A
- Risk Of Accident Caused By Vehicle Starting Off On Its Own When Jacked Up. Risk Of Injury Caused By Rotating Parts When Working On Running Engine Or Drive Train - AS00.00-Z-0008-01A
- Risk Of Injury. Moving Parts Can Pinch, Crush Or, In Extreme Cases Even Sever Extremities - AS00.00-Z-0009-01A
- Risk Of Death Caused By Vehicle Slipping Or Toppling Off Of The Lifting Platform - AS00.00-Z-0010-01A
- Risk Of Injury Caused By Fingers Being Jammed Or Pinched When Removing, Installing Or Aligning Hoods, Doors, Trunk Lid/Rear-End Door Or Sliding Roof - AS00.00-Z-0011-01A
- Risk Of Injury From Fingers Being Pinched Or Jammed When Working On Gas Struts Under Pressure - AS00.00-Z-0012-01A
- Risk Of Injury To Skin Or Eyes From Hydraulic Fluid Spraying Out Under Pressure. Risk Of Poisoning From Swallowing Hydraulic Fluid - AS00.00-Z-0013-01A
- Risk Of Injury Caused By Elastomer Bearings Or Bearing Parts Coming Loose Suddenly During Installation/Removal And Shooting Wildly Through The Air - AS00.00-Z-0014-01A
- Risk Of Explosion From Pressurized Spray Cans - AS00.00-Z-0015-01A
- Risk Of Poisoning Caused By Inhaling Vapors Or Swallowing Adhesive. Risk Of Injury Caused By Adhesive Coming Into Contact With Skin And Eyes - AS00.00-Z-0016-01A
- Risk Of Injury Caused By Scraping Or Cutting Body Parts On Sharp Vehicle Parts - AS00.00-Z-0017-01A
- Risk Of Explosion Due To Escaping Combustible Gas Or Overheating Of Gas Cylinders. Risk Of Injury Caused By Burns To Skin And Eyes. Risk Of Frostbite To Body Parts Caused By Escaping Gas And By Touching Components Near The Valves When Empty - AS00.00-Z-0018-01A
- Risk Of Death Caused By Body Parts Being Pulled In By Rotating Vehicle Wheels And Roller Dynamometer Rollers - AS00.00-Z-0019-01A
- Risk Of Death Caused By Work Performed On Liquified Gas Systems - AS00.00-Z-0022-01A
- Risk Of Injury From Engine Start By Remote Start Function - AS00.00-Z-0024-01A
- Risk Of Injury To Hands Or Eyes When Working On Hydraulic Pressure Reservoir Systems Caused By Hydraulic Fluid To Specification 345.0 Spraying Out Under Pressure - AS00.00-Z-0028-01A
- Risk Of Death Caused By Vehicle Slipping Or Toppling Off During Lifting - AS00.00-Z-0032-01A
- Risk Of Death When Working On Component Parts And Systems With U >= 30 V Alternating Voltage (AC) Or U >= 60 V Direct Voltage (DC) - AS00.00-Z-0035-01A
- Safety Information: Overall Vehicle - AS00.00-Z-9999ZZ
- Risk Of Injury Caused By Burns To Skin And Eyes. Risk Of Poisoning Caused By Inhaling Fumes When Working With Heat-Shrinkable Tubing - AS00.19-Z-0001-01A
- Risk Of Injury Caused By Burns To Skin And Eyes, Risk Of Poisoning Caused By Inhaling Fumes During Soldering - AS00.19-Z-0002-01A
- Risk Of Injury To Skin And Eyes Due To Handling Of Transmission Oil. Health Risk Caused By Swallowing Transmission Oil - AS00.40-Z-0001-01A
- Self-Diagnostic System
- Testing & Repair
- Check Gear Capacity - AR00.10-P-1010A
- Repair Wiring Harness By Crimping - AR00.19-P-0100-03A
- Repair Wiring Harness By Crimping (With Watertight Connections) - AR00.19-P-0100-04A
- Repairing Cable Harness By Soldering - AR00.19-P-0100-05A
- Repair Cable Harness Using Rapid Connection Technology - AR00.19-P-0100-06A
- Protect Repair Area After Cable Repairs - AR00.19-P-0100-08A
- Repairing Wiring Harness Using Solder Connectors - AR00.19-P-0100-09A
- Repair Wiring Harness With Line Cross-Section Of 0.13 mm2 Using Axial Solder Connector - AR00.19-P-0100-12A
- Remove Contacts From Micro Contact Connector - AR00.19-P-0100-13A
- General Repair Methods For Wiring Harness - AR00.19-P-0100A
- Remove Contacts From Sensor Laminated Contact Connector
- Remove Contacts From Sensor Laminated Contact Coupling - AR00.19-P-0120-02A
- Remove Contacts From Micro Quadlock System Connector
- Remove Contacts From Micro Quadlock System Coupling
- Remove Contacts From E 95 Coupling - AR00.19-P-0120-05A
- Remove Contacts From Micro Timer 3 Coupling - AR00.19-P-0120-06A
- Remove Contacts From Junior Power Timer Coupling - AR00.19-P-0120-07A
- Remove Contacts From Junior Power Timer Connector - AR00.19-P-0120-08A
- Remove Contacts From Multi Contact Point (MCP) Coupling - AR00.19-P-0120-09A
- Remove Contacts From Standard Power Timer Coupling - AR00.19-P-0120-10A
- Remove Contacts From Standard Power Timer Connector - AR00.19-P-0120-11A
- Remove Contacts From Fin Sensor Contact Coupling - AR00.19-P-0120-12A
- Remove Contacts From Fin Sensor Contact Connector - AR00.19-P-0120-13A
- Remove Contacts From Maxi Power Timer Coupling - AR00.19-P-0120-14A
- Remove Contacts From 2.5 Round Plug Contact Coupling - AR00.19-P-0120-15A
- Remove Contacts From 2.5 Plug Round Plug Contact - AR00.19-P-0120-16A
- Remove Contacts From 2.5 Solder Contact Coupling Round Plug Contact - AR00.19-P-0120-17A
- Remove Contacts From 2.5 Solder Contact Plug Round Plug Contact - AR00.19-P-0120-18A
- Remove Contacts From Laminated Contact System Coupling - AR00.19-P-0120-19A
- Remove Contacts From Laminated Contact System Plug - AR00.19-P-0120-20A
- Remove Contacts From Siemens ELO Coupling - AR00.19-P-0120-23A
- Remove Contacts From Siemens ELO Connector - AR00.19-P-0120-24A
- Remove Contacts From Mini Laminated Contact Coupling - AR00.19-P-0120-26A
- Remove Contacts From Mini Laminated Contact Plug - AR00.19-P-0120-27A
- Remove Contacts From Yazaki 1.5 System Coupling - AR00.19-P-0120-28A
- Remove Female Contact From Miniature Double Flat Spring Contact Coupling - AR00.19-P-0120-29A
- Remove Female Contact From Double Flat Spring Contact Coupling - AR00.19-P-0120-30A
- Remove/Install Contacts From Coupling Housing Of High-Voltage Disconnect Device - AR00.19-P-0120-31A
- Removing Contacts From Plugs And Connectors - AR00.19-P-0120A
- Secure Vehicle On Vehicle Lift With Support Arms - AR00.60-P-0100-01A
- Secure Vehicle On Vehicle Lift - AR00.60-P-0100CW
- Lift/Lower Vehicle - AR00.60-P-1002LWG
- Raise/Prop Up Vehicle With Pit Jack Or Vehicle Jack - AR00.60-P-1003A
- Raise/Prop Up Vehicle With Vehicle Lift - AR00.60-P-1005-01A
- Raise/Lower Vehicle With Vehicle Lift - AR00.60-P-1006A
- Maintenance
- Reception Report For Service At Vehicle - AP00.20-P-0009Z
- Read Out Maintenance Data From Instrument Cluster And Reset Service Indicator - AP00.20-P-0043E
- Reset Service Indicator To Previous Service - AP00.20-P-0044A
- Bring Up Workshop Level On Instrument Cluster - AP00.20-P-0046A
- Overview Of Vehicle-Specific Additional Operations Not Controlled Via Workshop Code - AP00.20-P-0047U
- Plus Package Service Items, General View - AP00.20-P-0048U
- Read Out Maintenance Data From Instrument Cluster And Reset Service Indicator, General View - AP00.20-P-0049U
- Check All Visible Parts Of Vehicle Underside For Damage And Fluid Loss - AP00.20-P-0054G
- Check All Visible Parts In Engine Compartment For Damage And Fluid Loss - AP00.20-P-0055E
- Overview Of Additional Operations At Customer Request - AP00.20-P-0059U
- Overview Of Check Before Driving Into Working Area - AP00.20-P-0062U
- Travel Inspection - AP00.20-P-0080A
- Spring Inspection - AP00.20-P-0081A
- Winter Inspection - AP00.20-P-0082A