LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> GT AMG >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brakes - Hydraulic & Mechanical System (1 Of 2) -- 190 Chassis >> Testing & Repair >> Bleed Brake System - AR42.10-P-0010RG

Bleed Brake System - AR42.10-P-0010RG

Model 190 

G16681708Courtesy of MERCEDES-BENZ USA
DANGER Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
DANGER Risk of poisoning  from swallowing brake fluid. Risk of injury  from skin and eye contact with brake fluid Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. AS42.50-Z-0001-01A 
NOTES Notes on repairs to brake system   AH42.00-P-0003-01A 
NOTES Notes on working in engine compartment   AH60.00-P-0042-01RG
NOTES Brake fluid notes   AH42.50-P-0001-01A 
NOTES Notes on handling, transport and storage of composite brake disks   AH42.10-P-9406-12LF 
REMOVING Remove     
1 Open engine hood    
2 Clean area surrounding cap (1)    
3 Open cap (1)    
4 Fill with new brake fluid up to the "MAX" mark in the brake fluid reservoir (2)    
REFER TO CAPACITIES & SPECIFICATIONS Brake fluids (DOT 4 plus)   BB00.40-P-0331-00A
REFER TO CAPACITIES & SPECIFICATIONS General brake fluid   BB00.40-P-0330-01A
5 Connect filler/bleeder unit to brake fluid reservoir (2) IMPORTANT Pay attention to manufacturer's operating instructions.  
6 Switch on filler/bleeder unit    
7 Lift vehicle on vehicle lift   AR00.60-P-1000RG
  Bleeding     
8 Carrying out bleeding operation   AR42.10-P-0010-02RK 
    TORQUE SPECIFICATION Bleed screw to brake caliper *BA42.10-P-1003-12T 
    TORQUE SPECIFICATION Bleed screw to brake caliper *BA42.10-P-1003-10T 
9 Switch off filler/bleeder unit    
10 Disconnect filler/bleeder unit from brake fluid reservoir (2)    
INSPECT Check     
11 Check brake system for leaks   AR42.10-P-0100-01V 
12 Check fluid level in brake fluid reservoir (2); correct if necessary    
REFER TO MAINTENANCE     AP42.10-P-4210A
INSTALLING Install     
13 Close cap (1)    
14 Close engine hood    
FRONT AXLE BRAKE CALIPER

Number Designation MODEL 190 with CODE B06 MODEL 190 with CODE B07
BA42.10-P-1003-10T Bleed screw to brake caliper Nm 18 18
FRONT AXLE BRAKE CALIPER

Number Designation MODEL 190 with CODE U70
BA42.10-P-1003-10T Bleed screw to brake caliper Nm 18
REAR AXLE BRAKE CALIPER

Number Designation MODEL 190
BA42.10-P-1003-12T Bleed screw to brake caliper Nm 18