Remove/Install Guide Rail For Panoramic Sliding Sunroof - AR77.21-S-0432E
Model 447.7/8, 448.8
Shown on right guide rail (1)
Shown on right guide rail (1)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Remove | |||
| 1 | Remove panoramic sliding roof | AR77.21-S-6923E | |
| 2 | Remove wind deflector for panoramic sliding roof | AR77.21-S-0101E | |
| 3 | Switch on ignition and move panoramic sliding roof mechanism with panoramic sliding roof switch to tilt position | ||
| 4 | Switch off ignition | ||
| 5 | Remove panoramic sliding roof drive unit | AR77.21-S-1000E | |
| 6 | Unscrew bolts (2, 3, 4) from left and right guide rail (1) | ||
| 7 | Remove front guide (5) from guide rail (1) | ||
| 8 | Lift guide rail (1) at front and remove together with installed cable (6) from guide tubes (7) | ||
| Disassemble/assemble | |||
| 9 | Disassemble guide rail (1) | When replacing guide rail (1). | AR77.21-S-0432-01E |
| 10 | Assemble in the reverse order | ||
| Install | |||
| 11 | Position front guide (5) on guide rail (1) | ||
| 12 | Push cable (6) into upper guide tube (7), push toward rear together with guide rail (1) and insert roller sun blind sliding shoe (11) into guide rail (1) | ||
| 13 | Connect roller sun blind driver (8) to roller sun blind sliding shoe (11) | ||
| 14 | Push guide rail (1) up to end stop of both guide tubes (7) | ||
| 15 | Lightly tighten bolts (2) by hand | ||
| 16 | Lightly tighten bolts (3) by hand | ||
| 17 | Adjust panoramic sliding roof mechanism by hand so that the bolt (4) can be screwed in | ||
| 18 | Tighten bolts (4) | ||
| 19 | Tighten bolts (2, 3) | ||
| 20 | Install panoramic sliding roof drive unit | AR77.21-S-1000E | |
| 21 | Install wind deflector for panoramic sliding roof | AR77.21-S-0101E | |
| 22 | Switch on ignition and move panoramic sliding roof mechanism with panoramic sliding roof switch to tilt position | ||
| 23 | Switch off ignition | ||
| 24 | Install Panoramic sliding sunroof | AR77.21-S-6923E | |
| Check | |||
| 25 | Perform function test of panoramic sliding sunroof and roller sun blind |