Remove/Install Trunk Lid Lock - AR88.50-P-0003LW
Model 205.0/1/3/4
Model 213.0/1
Model 238
Shown on model 205.0
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove panel at trunk lid (1) | Model 205.0/1 | AR68.30-P-8151LW |
| Model 205.3 | AR68.30-P-8151CLW | ||
| Model 205.4, 238.4 | AR68.30-P-8151LWR | ||
| Model 213.0/1, 238.3 | AR68.30-P-8151LWE | ||
| 2 | Unhook cable (2) from release (3) | Model 205.0/1, 213.0/1 | |
| 3 | Disconnect electrical connector (4) | ||
| 4.1 | Mark installation position of bolts (5) on trunk lid (1) | Model 205.0/1, 213.0/1 | |
| 4.2 | Mark installation position of trunk lid lock (6) on trunk lid (1) | Model 205.3/4, 238 | |
| 5 | Remove screw/bolts (5) | ||
| *BA88.50-P-1004-03A | |||
| 6 | Remove trunk lid lock (6) | ||
| 7 | Install in the reverse order |
TRUNK LID
| Number | Designation | Model 205 | Model 213 | |
|---|---|---|---|---|
| BA88.50-P-1004-03A | Bolt, trunk lid lock to trunk lid | Nm | 9 | 9 |
TRUNK LID
| Number | Designation | Model 238 | |
|---|---|---|---|
| BA88.50-P-1004-03A | Bolt, trunk lid lock to trunk lid | Nm | 9 |