Replace centering sleeve - AR41.10-P-0200SX

MODEL 216.3, 221.0 /1 

Shown on front half of propeller shaft 

Fig 1: Identifying Centering Sleeve, Flex Disk And Front Half Of Propeller Shaft

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove propeller shaft	without 4-Matic	AR41.10-P-0050SX
		With 4-MATIC	AR41.10-P-0050SYZ
2	Disconnect propeller shaft at slide connection	Installation:  Connect propeller shaft halves.	AR41.10-P-0050-05SX
	Checking
3	Check centering sleeves (10) in front and rear halves of propeller shaft	If the lip in the centering sleeve is worn or damaged, the centering sleeve must be replaced: ↓ Remove centering sleeve.	AR41.10-P-0200-02SX
		Press in centering sleeve.	AR41.10-P-0200-03SX
4	Fill cavities of both centering sleeves (10) with grease		*BF41.10-P-1001-01A
5	Install in the reverse order