Press in guide sleeve - AR41.10-P-0200-03SX

MODIFICATION NOTES

14.1.11

Value changed: Press-in dimension "a" from end face of centering sleeve to joint flange

Model 221.074/126/ 173/174/179

*BE41.10-P-1001-02N

CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE

Number	Designation			Model 221.003/022/ 026/028/056/ 071/073/103/ 122/128/156/ 171/176	Model 221.054/08/ 154/18
BE41.10-P-1001-02N	Press-in dimension "a" from face end of centering sleeve to joint flange	Front propeller shaft	mm	25, 3	23, 3
BE41.10-P-1001-02N		Rear propeller shaft	mm	28, 8	26, 8

CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE

Number	Designation			Model 221.057/070/ 094/157/170/ 194	Model 221.074/126/ 173/174/179
BE41.10-P-1001-02N	Press-in dimension "a" from face end of centering sleeve to joint flange	Front propeller shaft	mm	24, 8	25, 3
BE41.10-P-1001-02N		Rear propeller shaft	mm	28, 3	36, 2

CHECK VALUES FOR PROPELLER SHAFT ALIGNMENT SLEEVE

Number	Designation			Model 221.095	Model 221.195
BE41.10-P-1001-02N	Press-in dimension "a" from face end of centering sleeve to joint flange	Front propeller shaft	mm	24, 8	36, 3
BE41.10-P-1001-02N		Rear propeller shaft	mm	28.8	36, 2

Use a suitable drift to drive in the new guide sleeve.
Note press-in dimension "a" from the end face of the centering sleeve to the flange.

The specified press-in dimension "a" may deviate depending on the thickness of the flex disks (e.g. in vehicles with vibration damper). In these cases the dimension "a" measured prior to removal should be used for installation.

Fig 1: Driving In New Guide Sleeve

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Press In Dimension

Courtesy of MERCEDES-BENZ USA