Retrofit COMAND with APS navigation system - AN82.85-P-0003RTU
MODEL 251
MODIFICATION NOTES
| 17.1.11 | Connect/disconnect Star Diagnosis | Operation steps 7 and 10 | AD00.00-P-2000-04A |
| Enter new special equipment | Step 9 | AN00.01-P-1001-01V | |
| Document retrofitted equipment using vehicle documentation (VeDoc) added | Step 11 |
| Remove | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Remove dummy module from installation location of navigation processor | AR82.85-P-7373RT | |
| 2 | Remove left rear door sill molding | AR68.30-P-4100RT | |
| 3 | Remove left rear seat | AR91.12-P-1000RT | |
| Install | |||
| 4 | Install GPS antenna splitter (5) | Pull navigation processor GPS cable (6) out of cable duct (7) and connect to (black) output jack of GPS antenna splitter (5). |
AR82.70-P-8953RT |
| 5 | Fit navigation processor to radio | AR82.85-P-7373RT | |
| 6 | Install radio | AR82.60-P-7502RT | |
| 7 | Connect STAR DIAGNOSIS | AD00.00-P-2000-04A | |
| 8 | Configure navigation processor | AN82.85-P-0003-02RTU | |
| 9 | Enter special equipment in the vehicle data card and in the vehicle's online data card | ↓ |
|
| Initial startup of retrofits and modifications | AN00.01-P-1001-01V | ||
| 10 | Close STAR DIAGNOSIS | AD00.00-P-2000-04A | |
| 11 | Document retrofitted equipment using vehicle documentation (VeDoc) | ||
| 12 | Perform function test | ||
| 13 | Install left rear seat | AR91.12-P-1000RT | |
| 14 | Install left rear door sill molding | AR68.30-P-4100RT |
PARTS ORDERING NOTES
| Part no. | Designation | Quantity |
|---|---|---|
| B6 782 3581 | Navigation processor | 1 |
| B6 782 3111 | Antenna splitter | 1 |