Remove/install xenon bulb ignition module - AR82.10-P-4633P
MODEL 203.0 /2 /7, 209 up to 16.5.05 with CODE (614) Bi-xenon headlamp unit
Illustrated with bi-xenon headlamp unit code 614 installed
Fig 1: Identifying Xenon Bulb Ignition Module Remove/Install Components - Illustrated With Bi-Xenon Headlamp Unit Code 614 Installed
Illustrated on model 203.0/203.2 with bi-xenon headlamp unit code 614, ignition control unit replaced
Fig 2: Identifying Xenon Headlamp Ignition Module And Electrical Connector - Illustrated On Model 203.0/203.2 With Bi-Xenon Headlamp Unit Code 614
| Remove/install | |||
|---|---|---|---|
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard through highly flammable material in the area of damaged xenon bulbs Risk of injury through UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst Risk of poisoning through inhalation of mercury vapor and swallowing of or skin contact with toxic salts and mercury compounds |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off complete lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure that the workplace is sufficiently ventilated. | AS82.10-Z-0001-01A | |
| 1 | Switch off the ignition and remove the transmitter key from the EIS control unit | ||
| 2 | Open engine hood | Model 203 | AR88.40-P-1000P |
| Model 209 | AR88.40-P-1000Q | ||
| 3 | Remove finder liner in front fender | AR88.10-P-1300P | |
| 4 | Remove housing cover from front lamp unit | ||
| 5 | Remove xenon bulb ignition module | Model 203.0/2 | AR82.10-P-4633-01P |
| Model 203.7, 209 | AR82.10-P-4633-01Q | ||
| 6 | Install in the reverse order | ||
| 7 | Perform a function test |