Remove/install inner fender in front fender - AR88.10-P-1300P
MODEL 203, 209
Shown on model 203.0
Shown on model 203.0
| Remove/Install | |||
|---|---|---|---|
| Lethal injuries are possible if vehicle slips off of lifting platform | Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Remove front road wheel | ||
| Remove/install wheels, rotate if necessary | AP40.10-P-4050Z | ||
| 2 | Pull out body-bound rivets (4) | ||
| 3 | Unscrew screws (5). | ||
| 4 | Screw off nuts (6) | ||
| 5 | Remove front (1), middle (2) and rear (3) inner fender. | ||
| 6 | Install in the reverse order |