Convert xenon lamp ignition module - AR82.10-P-4633-01Q

Disconnect plug from headlamp.
Twist the ignition module plug to the left and detach.
Cut off plug as close to the ignition module as possible (arrows).
Dispose of ignition module plug.

Fig 1: Locating Ignition Module Plug
Cut off the three supply lines (red, black and green) as close to the ignition module as possible (arrow).
This shuts downs the ignition module in the headlamp.

Fig 2: Locating Supply Lines At Ignition Module
Solder the adapter cable onto the supply lines
Be careful not the damage the headlamp housing with the hot air gun.

Wind fabric tape around the solder connector (arrows).
Rotate plug of new ignition module into burner.

Fig 3: Identifying Adapter Cable And Supply Lines
Rotate lamp unit housing cover clockwise into place.
Fastening screw must be at the top.
Insert plug into headlamp.

Fig 4: Locating Lamp Unit Fastening Screw