Perform chassis alignment - AR40.20-P-0200P

MODEL 203, 209.3/ 4 

	Measuring, adjusting
1	Drive vehicle onto test site and secure by applying parking brake	The measuring system must be approved by Mercedes-Benz.
2	Carry out conditions and tests for chassis alignment		AR40.20-P-0260SX
3.1	Deactivate easy entry/exit feature	Vehicles with memory package (driver's seat, steering column, mirrors) code 275 Otherwise the driver seat and steering wheel move into a different position if the driver door is opened or closed for example. The seat may be damaged if the brake pedal winch is installed. The system is switched off via the buttons on the steering wheel in the "Comfort" menu of the multifunction display.
4	Using the adapter, install the brake pedal retaining tool between the pedal and the driver seat	Protect the brake pedal and driver seat otherwise the brake pedal or driver seat may be damaged.
			Fig 1
			Fig 2
5.1	Place the transmission in neutral	Vehicles with transmission 716.4/6
5.2	Move selector lever to position "P"	Vehicles with transmission 722.6/9
6	Open window on driver door and close driver door	Preparations for checking steering lock. The vehicle must not be loaded again.
7	Switch off ignition
8	Attaching Mercedes-Benz quick-clamping devices	Model 203	AR40.20-P-0230A
		Model 209	AR40.20-P-0230I
9	Fit on measuring heads
10	Unlock turnplates and sliding platforms
11	Check vehicle level at front and rear axle with electronic inclinometer, adjust if necessary	Depending on the measurement result the vehicle level must be adjusted at the front and rear axle.	AR40.20-P-0301P
12	Perform initial measurement
13.1	Checking rear axle camber	According to results of initial measurement. The camber at the rear axle is not adjustable.	AR40.20-P-0331P
14.1	Adjust rear-axle toe	According to results of initial measurement.	AR40.20-P-0261P
15.1	Adjust camber and caster at the front axle	According to results of initial measurement.
		Model 203 without 4matic, model 209	AR40.20-P-0263P
		Model 203 with 4MATIC	AR40.20-P-0263PW
16.1	Adjust front axle toe	According to results of initial measurement.	AR40.20-P-0264P
17	Perform final measurement
18	Detach sensors
19	Detach Mercedes-Benz quick-clamping devices	Model 203	AR40.20-P-0230A
		Model 209	AR40.20-P-0230I
20	Remove brake pedal jack tool with its adapter		Fig 1
			Fig 2
21	Drive vehicle off measuring system
22	Lock turntables and sliding platforms

Fig 1: Identifying Brake Pedal Winch (000 589 18 31 00)

Fig 2: Identifying Adapter For Brake Pedal Winch (211 589 00 31 00)