  |
Remove/Install |
|
|
 |
The shock absorber with the front spring does not have to be removed to remove and install the supporting joint. |
|
|
| 1 |
Remove front wheel |
|
|
 |
|
|
AP40.10-P-4050Z |
| 2.1 |
Detach twelve-point collar nut (61) of front axle shaft |
First version |
AR33.30-P-0620-01A |
| |
|
 |
*BA33.30-P-1001-02A |
 |
Caulker for securing twelve-point collar nut |
|
WF58.50-P-3330-01A |
 |
Bolted connection, front axle shaft to front axle shaft flange, modified |
|
BT33.30-P-0003-01D |
| 2.2 |
Detach hexagon collar bolt (61a) on front axle shaft |
Second version |
AR33.30-P-0620-05D |
| |
|
|
*BA33.30-P-1004-02A |
| 3 |
Press supporting joint (7) out of steering knuckle (5) |
Install new self-locking nut. |
AR33.20-P-0440-01D |
| |
|
Thrust piece |
Figure |
| |
|
Puller |
Figure |
| |
|
|
*BA33.20-P-1004-01A |
| 4 |
Pull steering knuckle (5) outwards and slide front axle shaft (60) out of front axle shaft flange |
Tie steering knuckle to one side using suitable wire. |
|
| 5 |
Support steering knuckle (arrow). |
Clamp a block of wood at the top between the steering knuckle and the front spring. |
|
| 6 |
Tie front axle shaft (60) to one side |
Do not damage the rubber boots and rpm sensor rotor. |
|
| 7 |
Press supporting joint (7) out of lower transverse control arm (4) |
Install new self-locking nut. |
AR33.20-P-0440-02D |
| |
|
|
Figure |
| |
|
|
*BA33.20-P-1006-01A |
| 8 |
Check supporting joint (7) |
Replace if necessary ↓
Installation:
After installing new supporting joint, apply an approved EP filler to protect it against corrosion. |
AR33.20-P-0425D |
| 9 |
Install in the reverse order |
|
|