LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2001 >> E430 Base >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Axle - 210 Chassis >> Testing & Repair >> Pressing out and installing supporting joint at steering knuckle - AR33.20-P-0440-01D

Pressing out and installing supporting joint at steering knuckle - AR33.20-P-0440-01D

SPECIAL TOOLTORQUE SPECIFICATIONReplace self-locking nut 

TORQUE SPECIFICATION Wheel Leadership, Hub

Number Designation Models 210.08/28
BA33.20-P-1004-01A Self-locking nut for supporting joint on steering knuckle Nm 105
Fig 1: Identifying Thrust Piece (140 589 00 63 00)
G04632419Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 2: Identifying Puller (140 589 09 33 00)
G04632420Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

    Pressing out 

  1. Unscrew self-locking nut from supporting joint (7).
  2. Mount thrust piece (07a).
  3. Using puller (07), press supporting joint (7) out of steering knuckle.
  4. Remove puller.

    5. Installation 

  5. Clean tapered connection.
  6. Replace and tighten self-locking nut.
    Fig 3: Identifying Self-Locking Nut From Supporting Joint
    G04632421Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals