LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2001 >> E430 Base >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Axle - 210 Chassis >> Testing & Repair >> Pressing out and installing supporting joint at lower wishbone - AR33.20-P-0440-02D

Pressing out and installing supporting joint at lower wishbone - AR33.20-P-0440-02D

SPECIAL TOOLTORQUE SPECIFICATIONReplace self-locking nut 

TORQUE SPECIFICATION Wheel location system, hub

Number Designation Models 210.08/28
BA33.20-P-1006-01A Self-locking nut for supporting joint on lower wishbone Nm 105
Fig 1: Identifying Puller (140 589 00 33 00)
G04632422Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

    Pressing out 

  1. Unscrew self-locking nut from supporting joint (7).
  2. Using puller (046), press supporting joint (7) out of lower wishbone.
  3. Remove puller.

    4. Installation 

  4. Clean tapered connection.
  5. Replace and tighten self-locking nut.

    Shown with lower wishbone installed 

    Fig 2: Identifying Supporting Joint With Puller
    G04632423Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals