LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> CX-5 Grand Select, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Entertainment System) >> D-Pillar Speaker Inspection >> D-pillar Speaker

D-pillar Speaker

WARNING: This page is about a different car, the 2016 Mazda CX-5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
    2. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    3. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    4. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
    5. D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the D-pillar speaker connector. (See D-PILLAR SPEAKER REMOVAL/INSTALLATION .)
  4. Verify that the resistance between the D-pillar speaker terminals is as indicated in the table.
    Fig 1: Identifying D-Pillar Speaker Connector Terminals
    G10939527Courtesy of MAZDA MOTORS CORP.
    • If not as indicated in the table, replace the D-pillar speaker.
    Fig 2: D-Pillar Speaker Terminals Resistance Chart
    G10939528Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals