Front Turn Light Short Cord Inspection

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
Remove the set plate. (See SET PLATE REMOVAL/INSTALLATION .)
Remove the front bumper. (See FRONT BUMPER REMOVAL .) (See FRONT BUMPER INSTALLATION .)
Remove the front turn light short cord. (See FRONT TURN LIGHT SHORT CORD REMOVAL/INSTALLATION .)
Verify that the continuity between the front turn light short cord terminals is as indicated in the table.

Fig 1: Front Turn Light Continuity Chart
Courtesy of MAZDA MOTORS CORP.

Fig 2: Locating Front Turn Light Connector
Courtesy of MAZDA MOTORS CORP.
- If not as indicated in the table, replace the front turn light short cord. (See FRONT TURN LIGHT SHORT CORD REMOVAL/INSTALLATION .)