Rear Side

Remove the following parts:
1. Front deflector (See FRONT DEFLECTOR REMOVAL/INSTALLATION .)
2. Front mudguard (See FRONT MUDGUARD REMOVAL/INSTALLATION .)
3. Front over fender (See FRONT OVER FENDER REMOVAL/INSTALLATION .)
4. Rear deflector (See REAR DEFLECTOR REMOVAL/INSTALLATION .)
Remove the screws. (with brackets)

Fig 1: Removing Screws (With Brackets)
Courtesy of MAZDA MOTORS CORP.
Remove the brackets. (with brackets)
Insert a remover tool in the position shown in the figure and remove the clip of the side step molding.

Fig 2: Inserting Remover Tool
Courtesy of MAZDA MOTORS CORP.
Pull the side step molding in the direction of arrow (2) shown in the figure while pulling the side step molding in the direction of arrow (1), and remove it.

Fig 3: Pulling Side Step Molding
Courtesy of MAZDA MOTORS CORP.
Remove clips A and B.

Fig 4: Removing Clips A And B

Courtesy of MAZDA MOTORS CORP.