Diagnostic Procedure
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | PERFORM DTC INSPECTION
|
Yes | Replace the BSM control module, then go to the next step. See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION . |
| No | Go to the next step. | ||
| 2 | VERIFY THAT NO OTHER DTCs ARE RECORDED
|
Yes | Go to the applicable DTC inspection. See DTC TABLE [BLIND SPOT MONITORING (BSM)] . |
| No | DTC troubleshooting completed. | ||