Diagnostic Procedure
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | INSPECT POWER OUTER MIRROR (RH) CONNECTOR CONDITION
|
Yes | Repair or replace the connector or terminal, then go to Step 6. |
| No | Go to the next step. | ||
| 2 | INSPECT BSM CONTROL MODULE (RH) CONNECTOR CONDITION
|
Yes | Repair or replace the connector or terminal, then go to Step 6. |
| No | Go to the next step. | ||
| 3 | INSPECT BSM INDICATOR LIGHT (RH) CONTROL CIRCUIT FOR SHORT TO GROUND
|
Yes | Repair or replace the wiring harness for a possible short to ground, then go to Step 6. |
| No | Go to the next step. | ||
| 4 | INSPECT POWER OUTER MIRROR (RH)
|
Yes | Replace the power outer mirror (RH), then go to Step 6. See POWER OUTER MIRROR REMOVAL/INSTALLATION . |
| No | Go to the next step. | ||
| 5 | INSPECT BSM INDICATOR LIGHT (RH)
|
Yes | Replace the outer mirror glass (RH), then go to the next step. See OUTER MIRROR GLASS REMOVAL . See OUTER MIRROR GLASS INSTALLATION . |
| No | Go to the next step. | ||
| 6 | VERIFY TROUBLESHOOTING COMPLETED
|
Yes | Replace the BSM control module (RH), then go to the next step. See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION . |
| No | Go to the next step. | ||
| 7 | VERIFY THAT NO OTHER DTCs ARE RECORDED
|
Yes | Go to the applicable DTC inspection. See DTC TABLE [BLIND SPOT MONITORING (BSM)] . |
| No | DTC troubleshooting completed. | ||