LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> 6 i Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 606 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures >> Deployment Procedure for Inside of Vehicle >> Pre-tensioner Seat Belt

Pre-tensioner Seat Belt

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front scuff plate. (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
  2. Remove the rear scuff plate. (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
  3. Remove the B-pillar lower trim. (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
  4. Remove the pre-tensioner seat belt and connect the SST (Adapter harness)  as shown in the figure. (See FRONT SEAT BELT REMOVAL/INSTALLATION .)
    5. Fig 1: Connecting SST To Pre-Tensioner Seat Belt
    G06200476Courtesy of MAZDA MOTORS CORP.
  5. Install the pre-tensioner seat belt.
  6. Connect the SST (Deployment tool)  to the SST (Adapter harness)  .
    7. Fig 2: Connecting Deployment Tool To SST
    G06200471Courtesy of MAZDA MOTORS CORP.
  7. Connect the SST (Deployment tool)  to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the negative battery terminal.
  8. Verify that the red lamp on the SST (Deployment tool)  is illuminated.
  9. Verify that all persons are standing at least 6 m {20 ft}  away from the vehicle.
  10. Press the activation switch on the SST (Deployment tool)  to operate (deploy) the pre-tensioner seat belt.
    Fig 3: Identifying Activation Switch On SST
    G06200465Courtesy of MAZDA MOTORS CORP.
    WARNING:
    • The pre-tensioner seat belt is very hot immediately after it is operated (deployed). You can be burned. Do not touch the pre-tensioner seat belt for at least 15 min after deployment.
  11. Disconnect the SST (Deployment tool)  from the SST (Adapter harness)  .
scientia non olet · About LEMON Manuals