LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center [Instrumentation/Driver Info] >> Info Switch Inspection

Info Switch Inspection

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Front scuff plate (Driver side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Front side trim (Driver side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION .)
    4. Decoration panel (Driver side) (See DECORATION PANEL REMOVAL/INSTALLATION .)
    5. Hood release lever (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
    6. Meter hood (See METER HOOD REMOVAL/INSTALLATION .)
    7. Lower panel (Driver side) (See LOWER PANEL REMOVAL/INSTALLATION .)
    8. INFO switch (See INFO SWITCH REMOVAL/INSTALLATION .)
  3. Verify that the continuity between the INFO switch terminals is as indicated in the table.
    • If not as indicated in the table, replace the INFO switch.
    Fig 1: INFO Switch Terminal Continuity Chart
    G07622519Courtesy of MAZDA MOTORS CORP.
    Fig 2: INFO Switch Circuit
    G07622520Courtesy of MAZDA MOTORS CORP.
  4. Apply battery positive voltage to INFO switch terminal E, and connect terminal A to ground.
  5. Verify that the LED illuminates.
scientia non olet · About LEMON Manuals