LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2007 >> B4000 SE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission [Service, Removal & Installation 5R44E/5R55E]) >> Intermediate Servo Removal / Installation >> Removal Note

Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Remove the control valve body. See CONTROL VALVE BODY REMOVAL / INSTALLATION , .
  2. Remove the shift cable.
    1. Disconnect the shift cable from the manual control lever.
    2. Remove the shift cable from the bracket.
    Fig 1: Identifying Shift Cable
    G04930409Courtesy of MAZDA MOTORS CORP.
  3. Remove the digital transmission range (TR) sensor. See DIGITAL TRANSMISSION RANGE SENSOR REMOVAL / INSTALLATION , .
    NOTE:
    • If equipped, the transmission servo heat shield needs to be undipped from the fluid pan rail and positioned out of the way for fluid pan removal.
  4. Loosen the nut and position the heat shield out of the way.
    Fig 2: Removing Transmission Modulator Heat Shield
    G04930400Courtesy of MAZDA MOTORS CORP.
  5. Remove the intermediate band locknut and unscrew the intermediate band adjusting screw.
    • Discard the intermediate band locknut after removal.
    Fig 3: Locating Intermediate Band Locknut
    G04930411Courtesy of MAZDA MOTORS CORP.
  6. Remove the catalytic converter. See THREE-WAY CATALYTIC CONVERTER REMOVAL / INSTALLATION - 2.3L , for 2.3L engine, see THREE-WAY CATALYTIC CONVERTER REMOVAL / INSTALLATION - 3.0L , for 3.0L engine or see THREE-WAY CATALYTIC CONVERTER REMOVAL / INSTALLATION - 4.0L , for 4.0L engine.
    CAUTION:
    • Servo cover is under spring tension. Use caution when removing.
  7. Using the servo cover compressor SST  , remove the intermediate band servo cover retaining ring.
    1. Install the servo cover compressor SST  and compress the intermediate band servo cover.
    2. Remove the intermediate servo cover retaining ring.
      • Slowly remove tension on the J hook nut and remove the servo cover compressor.
    Fig 4: Identifying Servo Cover Compressor SST With Retaining Ring
    G04930412Courtesy of MAZDA MOTORS CORP.
  8. Using servo cover compressor SST  , remove the overdrive band servo cover retaining ring.
    1. Install the servo cover compressor SST  and compress the overdrive/front band servo cover.
    2. Remove the overdrive/front servo cover retaining ring.
      • Slowly remove tension on the J-hook nut and remove the servo cover compressor.
      CAUTION:
      • The servo removal tool SST should be used to prevent damage to the servo and bore.
  9. Use the servo removal tool SST  to remove the front band servo cover, servo piston and servo piston spring.
    1. Insert the servo removal tool SST  into the transmission case, locate on the servo rod, and remove the front band servo cover, servo piston and servo piston spring.
    Fig 5: Identifying Servo Removal Tool SST
    G04930403Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals