Washer Pump And Reservoir Removal/Installation

NOTE:

To prevent spilling windshield washer fluid, drain the windshield washer reservoir before removal.

Disconnect the windshield washer hose from the windshield washer pump.
Disconnect the engine coolant overflow hose from the reservoir and plug the outlet port.
Disconnect the washer pump electrical connector.
Position the air cleaner element aside.
See AIR CLEANER ELEMENT REMOVAL/INSTALLATION - 2.3L or AIR CLEANER ELEMENT REMOVAL/INSTALLATION - 3.0L or AIR CLEANER ELEMENT REMOVAL/INSTALLATION - 4.0L .
Remove the two screws and two nuts and remove the reservoir.

Fig 1: Removing Reservoir Screws And Nuts
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- When removing the washer pump from the reservoir be sure not to damage the rubber grommet.
Remove the washer pump from the reservoir.

Fig 2: Removing Washer Pump From Reservoir
Courtesy of MAZDA MOTORS CORP.
NOTE:
- The reservoir and the washer pump are to be replaced independently.
Install in the reverse order of removal.
Tightening torque

5 - 6 N.m {51-61 kgf.cm, 44 - 53 in.lbf}