LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> GX 550 Overtrail >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (1 Of 2) >> Hood Lock Control Cable Assembly >> Removal [12/2023 - ] >> Procedure

Removal [12/2023 - ]: Procedure

  1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 16

  2. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 
    1. GTY1217821Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 
    1. GTY1219552Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 1

  5. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR 
    1. GTY1217823Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE HOOD LOCK ASSEMBLY 
    1. GTY1217822Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE ENGINE SIDE COVER LH 

    See step  1

  8. REMOVE FRONT FENDER TOP REINFORCEMENT SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 3

  9. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY 
    1. GTY1213958Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
      1. Tie a string to the end of the hood lock control cable assembly in the cabin.

        HINT: 

        Use a length of string long enough to pass through the engine compartment.

      2. Detach the clamp.
      3. Remove the grommet as shown in the illustration.
    2. GTY1210892Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Detach the clamp and remove the hood lock control cable assembly.
scientia non olet · About LEMON Manuals