Removal [09/2018 - 10/2020]: Procedure
- PRECAUTION WARNING:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [10/2017 - 10/2020]
NOTE:After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [10/2017 - 09/2019] , or refer to PRECAUTION [09/2019 - 10/2020]
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 3
WARNING:- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Refer to PRECAUTION [10/2017 - 10/2020]
- If the airbag deploys for any reason, it may cause a serious accident.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [09/2018 - 10/2020]
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 7
- REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 8
- REMOVE FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 13
- REMOVE COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 9
- REMOVE LOWER NO. 1 INSTRUMENT PANEL PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 8
- REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH
Refer to PROCEDURE - Step 3
- REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 10
- REMOVE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) NOTE:
Do not reuse dropped or damaged parts.