LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Seat Belt) >> Child Restraint Seat Tether Anchor >> Installation

Child Restraint Seat Tether Anchor: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET 
    1. Install the 2 child restraint seat tether anchor brackets with the 2 bolts.

      Torque: 21 N*m (214 kgf*cm, 16 ft.*lbf) 

      Fig 1: Identifying Child Restraint Seat Tether Anchor Brackets Bolts
      G05013665Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY  (See INSTALLATION  )
  3. INSTALL CENTER STOP LIGHT SET  (See INSTALLATION )
  4. INSTALL ROOF SIDE INNER GARNISH LH  (See INSTALLATION )
  5. INSTALL ROOF SIDE INNER GARNISH RH  (See INSTALLATION )
  6. INSTALL REAR SEAT SIDE GARNISH LH  (See INSTALLATION )
  7. INSTALL REAR SEAT SIDE GARNISH RH  (See INSTALLATION )
  8. INSTALL REAR DOOR SCUFF PLATE LH  (See INSTALLATION )
  9. INSTALL REAR DOOR SCUFF PLATE RH  (See INSTALLATION )
  10. INSTALL REAR SEATBACK ASSEMBLY  (See INSTALLATION )
  11. INSTALL REAR SEAT CUSHION ASSEMBLY  (See INSTALLATION )
  12. INSTALL REAR SEAT HEADREST ASSEMBLY LH 
  13. INSTALL REAR SEAT HEADREST ASSEMBLY RH 
scientia non olet · About LEMON Manuals