LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2008 >> IS 250 RWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Theft Deterrent / Keyless Entry) >> Engine Hood Courtesy Switch >> Installation

Engine Hood Courtesy Switch: Installation

WARNING: This page is about a different car, the 2008 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)  (See INSTALLATION )
  2. INSTALL HOOD LOCK NUT CAP  (See INSTALLATION )
  3. INSTALL HOOD LOCK CONTROL CABLE COVER  (See INSTALLATION )
  4. INSTALL LOW PITCHED HORN ASSEMBLY  (See INSTALLATION )
  5. INSPECT HOOD SUB-ASSEMBLY  (See ON-VEHICLE INSPECTION )
  6. ADJUST HOOD SUB-ASSEMBLY  (See ADJUSTMENT )
  7. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)  (See INSTALLATION )
  8. INSTALL FRONT BUMPER ASSEMBLY  (See INSTALLATION )
  9. INSTALL RADIATOR GRILLE PROTECTOR  (See INSTALLATION )
  10. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  11. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)  (See ADJUSTMENT )
  12. VEHICLE PREPARATION FOR FOG LIGHT AIM  (See ADJUSTMENT )
  13. PREPARATION FOR FOG LIGHT (See  ADJUSTMENT  ) 
  14. INSPECT FOG LIGHT AIM  (See ADJUSTMENT )
  15. ADJUST FOG LIGHT AIM  (See ADJUSTMENT )
scientia non olet · About LEMON Manuals