Parking Brake Cable: Removal

HINT:

• Use the same procedures for the RH side and the LH side.
• The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL 
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH 
   1. Remove the 2 bolts and separate the rear disc brake caliper assembly LH.

      HINT:

      Do not disconnect the flexible hose from the rear brake caliper assembly LH.

3. REMOVE REAR DISC  (See DISASSEMBLY  )
4. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING  (See DISASSEMBLY  )
5. REMOVE PARKING BRAKE SHOE STRUT SET LH  (See DISASSEMBLY  )
6. REMOVE PARKING BRAKE SHOE ASSEMBLY LH NO.1  (See DISASSEMBLY  )
7. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET LH  (See DISASSEMBLY  )
8. REMOVE PARKING BRAKE SHOE ASSEMBLY LH NO.2  (See DISASSEMBLY  )
9. SEPARATE SPEED SENSOR REAR LH (for 4WD)  (See REMOVAL )
10. REMOVE REAR AXLE SHAFT LH NUT (for 4WD)  (See REMOVAL )
11. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH (for 4WD)  (See REMOVAL )
12. REMOVE PARKING BRAKE CABLE ASSEMBLY NO. 3 
    Fig 1: Identifying Backing Plate Bolts

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 2 bolts and separate the parking brake cable assembly No. 3 from the backing plate.
    2. Remove the 4 nuts and 2 bolts and separate the parking brake cable assembly No. 3 from the body.
    3. Separate the parking brake cable assembly No. 3 from the equalizer and remove the parking brake cable assembly No. 3.
    Fig 2: Identifying Parking Brake Cable Support Bracket
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the parking brake cable support bracket No. 1 from the parking brake cable assembly No. 3.