REAR AXLE HUB AND BEARING (For 4WD): Removal

HINT:

Replace the RH side using the same procedures as for the LH side.

1. REMOVE REAR WHEEL 
2. SEPARATE SPEED SENSOR REAR LH 
   1. remove the bolt and separate the speed sensor from the axle carrier.
      NOTE:

      • Be careful not to damage the speed sensor.
      • Prevent foreign matter from adhering to the speed sensor.
3. REMOVE REAR AXLE SHAFT LH NUT 
   1. Using SST(s) and a hammer, unstake the staked part of the axle hub LH nut.

      SST 09930-00010 

      NOTE: Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.
   2. While applying the brakes, remove the lock axle hub LH nut.
      Fig 1: Removing Rear Axle Shaft LH Nut

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH 
   1. Remove the bolt, and separate the flexible hose from the shock absorber.
   2. Remove the 2 bolts and separate rear disc brake caliper assembly.
      Fig 2: Identifying Rear Disc Brake Caliper Assembly Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: Use a string or other device to keep the brake caliper from hanging down.
5. REMOVE REAR DISC 
6. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH 
   1. Remove the 4 bolts and the rear axle hub & bearing assembly LH.
      Fig 3: Identifying Rear Axle Hub & Bearing Assembly LH Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002