LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Panel System - Body Closures -- XF/(X260) >> Body Closures (G1861181) >> Diagnosis And Testing >> Luggage Compartment Lid (G2218355) >> Module DTC Verification And Testing (Luggage Compartment Lid) >> Pinpoint Test B: Luggage Compartment Lid Does Not Open

Pinpoint Test B: Luggage Compartment Lid Does Not Open

  1. B1: SWITCH TEST 
    NOTE: Before beginning this pinpoint test it may be useful to complete Pinpoint Test S, if not already completed
    1. Using the Jaguar Land Rover Approved Diagnostic Equipment, check all associated DTCs with the central junction box & luggage compartment lid control module
    2. DO NOT REPAIR DTCS - NO PARTS TO BE CHANGED WITHOUT FIRST ISOLATING THE FAILURE MODE

      Are there any DTCs present in the luggage compartment lid control module?

      Yes:  GO to PINPOINT TEST A: DTC TEST 

      No:  GO to  B2.

  2. B2: SWITCH TEST 
    1. Press the exterior luggage compartment lid close switch

      Can you hear the latch actuate?

      Yes:  Follow steps 3 and 4 then Go to 5

      No:  GO to  B3.

  3. B3: SWITCH TEST 
    1. Press the smart key luggage compartment lid close switch

      Can you hear the latch actuate?

      Yes:  Follow steps 2 and 4 if not already performed, then Go to 5

      No:  GO to  B4.

  4. B4: SWITCH TEST 
    1. Press the interior luggage compartment lid close switch

      Can you hear the latch actuate?

      Yes:  Follow steps 2 and 3 if not already performed, then Go to 5

      No:  GO to  B5.

  5. B5: SWITCH TEST 
    1. After testing all three luggage compartment lid close switch operations

      Did the latch actuate from all three switch inputs?

      Yes:  GO to  B6.

      No:  Refer to the electrical circuit diagrams and check the luggage compartment lid close switch for open circuit, high resistance, repair the circuit as necessary. Refer to the relevant article of the repair information and install a new part as required. If this fails to remedy the failure GO to  B7. 7

      Check the release switch concerned for any obvious damage or corrosion

      On the warranty claim please quote feedback ID "FID 2.1"

  6. B6: STRIKER RELEASE 
    1. After testing all three luggage compartment lid close switch operations

      During actuation did the latch release from the striker?

      Yes:  GO to PINPOINT TEST E .

      No:  GO to PINPOINT TEST C .

  7. B7: CAN BUS 
    1. Using the Jaguar Land Rover Approved Diagnostic Equipment, check if the central junction box is live on the medium speed CAN bus

      Is the central junction box live on the CAN bus?

      Yes:  GO to PINPOINT TEST C .

      No:  Refer to the electrical circuit diagrams and check the central junction box power and ground circuits for open circuit, high resistance, repair the circuit as necessary

      Using the Jaguar Land Rover Approved Diagnostic Equipment, perform a CAN network integrity test. Refer to the electrical circuit diagrams and check the high speed CAN bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance, repair the circuit as necessary

      Using the Jaguar Land Rover Approved Diagnostic Equipment, check the central junction box for related DTCs and refer to the relevant DTC index

scientia non olet · About LEMON Manuals