LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2023 >> XF R-Dynamic SE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Panel System - Body Closures -- XF/(X260) >> Body Closures (G1861181) >> Diagnosis And Testing >> Luggage Compartment Lid (G2218355) >> Module DTC Verification And Testing (Luggage Compartment Lid) >> Pinpoint Test A: DTC Test

Pinpoint Test A: DTC Test

  1. A1: DTC TEST 
    1. Using the Jaguar Land Rover Approved Diagnostic Equipment, check for any DTCs present in the luggage compartment lid control module
    2. Take a session file to share with Land Rover Engineering
    3. Using the Jaguar Land Rover Approved Diagnostic Equipment, reconfigure the luggage compartment lid control module with the latest level software

    Are there DTCs present in the luggage compartment lid control module?

    Yes:  GO to  A2.

    No:  Go to the relevant Primary Pinpoint Test according to the reported failure mode on the vehicle. GO to PINPOINT TEST S .

  2. A2: DTC TEST 
    1. Clear down all DTC's from the luggage compartment lid control module. Perform the following sequence of operations;
    2. Try to cycle (open then close) the luggage compartment lid 6 times. Listen for soft close actuator initializing. In all cases wait for 5 seconds before attempting to re-open the luggage compartment lid
    3. If a powered operation is not possible, open the luggage compartment lid and then close the latch to secondary latched position (safety catch, not fully closed, but latched) and listen for soft close actuator initialization
    4. Close all doors and luggage compartment lid on the vehicle, then press the smart lock button twice
    5. Wait for 30 seconds
    6. Unlock the vehicle, then using the Jaguar Land Rover Approved Diagnostic Equipment, read out all DTCs present in the luggage compartment lid control module. If DTCs are present take another session file to share with Land Rover Engineering

    Were any DTCs present in the module following this sequence?

    Yes:  GO to  A3.

    No:  Go to the relevant Primary Pinpoint Test according to the reported failure mode on the vehicle. GO to PINPOINT TEST S .

  3. A3: DTC TEST 
    1. Evaluate the DTCs present

      Is B11C4-23 present?

      Yes:  GO to PINPOINT TEST B . SWITCH TEST part 2

      No:  GO to  A4.

  4. A4: DTC TEST 
    1. Evaluate the DTCs present

      Is B1161-15 or B1162-15 present?

      Yes:  GO to PINPOINT TEST F : LUGGAGE COMPARTMENT LID ANTI-TRAP SENSOR TESTING part 1

      No:  GO to  A5.

  5. A5: DTC TEST 
    1. Evaluate the DTCs present

      Is B1463-02, B1463-11 or B1464-02 present?

      Yes:  GO to PINPOINT TEST D . SOFT CLOSE ACTUATOR TEST part 2

      No:  GO to  A6.

  6. A6: DTC TEST 
    1. Evaluate the DTCs present

      Is B1316-93 present?

      Yes:  GO to PINPOINT TEST D . SOFT CLOSE ACTUATOR TEST part 3

      No:  GO to  A7.

  7. A7: DTC TEST 
    1. Evaluate the DTCs present

      Is B1316-02 present?

      Yes:  GO to PINPOINT TEST D . SOFT CLOSE ACTUATOR TEST part 5

      No:  GO to  A8.

  8. A8: DTC TEST 
    1. Evaluate the DTCs present

      Is C2005-19 or C2006-19 present?

      Yes:  GO to PINPOINT TEST K . MECHANICAL OBSTRUCTION INSPECTION part 1

      No:  GO to  A9.

  9. A9: DTC TEST 
    1. Evaluate the DTCs present

      Is C2005-11/12/13, C2006-11/12/13 present?

      Yes:  GO to PINPOINT TEST E . LUGGAGE COMPARTMENT LID ACTUATOR TEST part 4

      No:  GO to  A10.

  10. A10: DTC TEST 
    1. Evaluate DTCs present. Compare them against the following; C2005-15 C2006-15

      Were any of the above DTCs present in the luggage compartment lid control module?

      Yes:  GO to PINPOINT TEST I . LUGGAGE COMPARTMENT LID POSITIONAL DATA TEST part 3

      No:  GO to  A11.

  11. A11: DTC TEST 
    1. Evaluate DTCs present. Compare them against the following; C2005-31 C2006-31

      Were any of the above DTCs present in the luggage compartment lid control module?

      Yes:  GO to PINPOINT TEST I . LUGGAGE COMPARTMENT LID POSITIONAL DATA TEST part 2

      No:  GO to  A12.

  12. A12: DTC TEST 
    1. Evaluate the DTCs present

      Is C2005-31 or C2006-31 present?

      Yes:  GO to PINPOINT TEST I . LUGGAGE COMPARTMENT LID POSITIONAL DATA TEST part 1

      No:  GO to  A13.

  13. A13: DTC TEST 
    1. Evaluate the DTCs present

      Is U0140-00, U0401-68 or U0415-68 present?

      Yes:  GO to PINPOINT TEST E . LUGGAGE COMPARTMENT LID ACTUATOR TEST part 6

      No:  GO to  A14.

  14. A14: DTC TEST 
    1. Evaluate the DTCs present. Compare them against the following; U201A-51 U201A-52 U0300-00 U2100-00 U2101-00 U3000-44 U3000-45 U3000-46 U3000-49

      Were any of these DTCs present?

      Yes:  Refer to the relevant article of the repair information and install a new luggage compartment lid control module as necessary - on the warranty claim please quote feedback "FID 1.1"

      No:  GO to  A15.

  15. A15: DTC TEST 
    1. Evaluate the DTCs present. Compare them against the following; C2005-11/12/13 C2006-11/12/13 U0140-00 U0401-68 U0415-68 U201A-51 U201A-52 U0300-00 U2100-00 U2101-00 U3000-44 U3000-45 U3000-46 U3000-49

      Were any of the above DTCs present in the luggage compartment lid control module?

      Yes:  GO to PINPOINT TEST B . LUGGAGE COMPARTMENT LID DOES NOT OPEN

      No:  GO to  A16.

  16. A16: DTC TEST 
    1. Evaluate DTCs present. Compare them against the following; B1463-02 B1463-11 B1464-02

      Were any of the above DTCs present in the luggage compartment lid control module?

      Yes:  GO to PINPOINT TEST D . SOFT CLOSE ACTUATOR TEST

      No:  Go to the relevant Pinpoint Test according to the reported failure mode on the vehicle GO to PINPOINT TEST S .