Pinpoint Test E: Luggage Compartment Lid Actuator Test
- E1: LUGGAGE COMPARTMENT LID ACTUATOR TEST NOTE: Before beginning this pinpoint test it may be useful to complete Pinpoint Test S, if not already completed
- Operate a luggage compartment lid release switch and check the luggage compartment lid opens fully
Did the luggage compartment lid begin to power open from the actuator(s) without opening fully?
Yes: GO to PINPOINT TEST G .
No: GO to E2.
- Operate a luggage compartment lid release switch and check the luggage compartment lid opens fully
- E2: LUGGAGE COMPARTMENT LID ACTUATOR TEST
- Open the luggage compartment lid through its throw of operation manually
Does the system resist movement significantly more than other vehicles?
Yes: Ensure that there is no mechanical obstruction preventing movement of the luggage compartment lid. If none present, Refer to the relevant article of the repair information and install a new luggage compartment lid actuator as necessary
On the warranty claim please quote feedback ID "FID 2.10"
No: GO to E3.
- Open the luggage compartment lid through its throw of operation manually
- E3: LUGGAGE COMPARTMENT LID ACTUATOR TEST
- Inspect the anti-trap sensors on either side of the luggage compartment lid. Pay particular attention to the radius at the top of the luggage compartment lid
Is there evidence of abrasion/wear and tear?
Yes: Using the Jaguar Land Rover Approved Diagnostic Equipment, check datalogger signal - Anti Pinch Seals Voltage D902 when the luggage compartment lid is closed. If the signal indicates that the sensor is activated, Refer to the relevant article of the repair information and install a new sensor as necessary. Also check the drain trough finishers in the affected area for correct fitment. Ensure clearance is achieved after refitting the anti-trap sensor
On the warranty claim please quote feedback ID "FID 2.11"
No: GO to E4.
- Inspect the anti-trap sensors on either side of the luggage compartment lid. Pay particular attention to the radius at the top of the luggage compartment lid
- E4: LUGGAGE COMPARTMENT LID ACTUATOR TEST
- Refer to the electrical circuit diagrams and check the luggage compartment lid actuator(s) by measuring resistance across terminals C4PL21B-2 and C4PL21B-9 for the right hand actuator and terminals C4PL21A-2 and C4PL21A-9 for the left hand actuator
Is the resistance between 2 ohms and 20 ohms?
Yes: GO to E5.
No: Refer to the relevant article of the repair information and install new luggage compartment lid actuator(s) as necessary. DTC C2005-11/13/31 or C2006-11/13/31 should be present in the luggage compartment lid control module as a hard fault
On the warranty claim please quote feedback ID "FID 2.12"
- Refer to the electrical circuit diagrams and check the luggage compartment lid actuator(s) by measuring resistance across terminals C4PL21B-2 and C4PL21B-9 for the right hand actuator and terminals C4PL21A-2 and C4PL21A-9 for the left hand actuator
- E5: LUGGAGE COMPARTMENT LID ACTUATOR TEST
- Refer to the electrical circuit diagrams and check the luggage compartment lid actuator circuit for open circuit, high resistance
Is the luggage compartment lid actuator circuit open circuit, high resistance?
Yes: Repair the circuit as necessary
On the warranty claim please quote feedback ID "FID 2.13"
No: GO to E6.
- Refer to the electrical circuit diagrams and check the luggage compartment lid actuator circuit for open circuit, high resistance
- E6: LUGGAGE COMPARTMENT LID ACTUATOR TEST
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check if the central junction box is live on the medium speed CAN bus
Is the central junction box live on the CAN bus?
Yes: GO to E7.
No: Refer to the electrical circuit diagrams and check the central junction box power and ground circuits for open circuit, high resistance, repair the circuit as necessary. DTCs U0140-00, U0401-68 and U0415-68 may also be present on the luggage compartment lid control module as hard faults
Using the Jaguar Land Rover Approved Diagnostic Equipment, perform a CAN network integrity test. Refer to the electrical circuit diagrams and check the high speed CAN bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance, repair the circuit as necessary
Using the Jaguar Land Rover Approved Diagnostic Equipment, check the central junction box for related DTCs and refer to the relevant DTC index
On the warranty claim please quote feedback ID "FID 2.14"
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check if the central junction box is live on the medium speed CAN bus
- E7: LUGGAGE COMPARTMENT LID ACTUATOR TEST
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check if the luggage compartment lid control module is live on the medium speed CAN bus
Is the luggage compartment lid control module live on the CAN bus?
Yes: GO to PINPOINT TEST H .
No: Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the DTCs and retest. If the fault persists, install a new luggage compartment lid control module as necessary
On the warranty claim please quote feedback ID "FID 2.15"
- Using the Jaguar Land Rover Approved Diagnostic Equipment, check if the luggage compartment lid control module is live on the medium speed CAN bus