Pinpoint Test C: Luggage Compartment Lid Latch Test
- C1: LATCH TEST NOTE: Before beginning this pinpoint test it may be useful to complete Pinpoint Test S, if not already completed
- Refer to the relevant article of the repair information and remove the luggage compartment lid trim for access to the luggage compartment lid latch
- Try to release the luggage compartment lid latch with the emergency release lever
Does the luggage compartment lid latch release?
Yes: GO to C2.
No: Refer to the relevant article of the repair information and install a new luggage compartment lid latch assembly as necessary
On the warranty claim please quote feedback ID "FID 2.2"
- Refer to the relevant article of the repair information and remove the luggage compartment lid trim for access to the luggage compartment lid latch
- C2: LATCH TEST
- Measure the resistance of the luggage compartment lid soft close actuator across terminals C4PL61-3 and C4PL61-2
Is the resistance between 2 ohms and 20 ohms?
Yes: GO to C3.
No: Refer to the relevant article of the repair information and install a new luggage compartment lid latch assembly as necessary
On the warranty claim please quote feedback ID "FID 2.3"
- Measure the resistance of the luggage compartment lid soft close actuator across terminals C4PL61-3 and C4PL61-2
- C3: LATCH TEST
- Refer to the electrical circuit diagrams and check the luggage compartment lid soft close actuator circuit for open circuit, high resistance
Is the luggage compartment lid soft close actuator circuit open circuit, high resistance?
Yes: Repair the circuit as necessary
On the warranty claim please quote feedback ID "FID 2.4"
No: GO to C4.
- Refer to the electrical circuit diagrams and check the luggage compartment lid soft close actuator circuit for open circuit, high resistance
- C4: LATCH TEST
- Measure the voltage at the luggage compartment lid latch during actuation at C4PL61-3
Is the actuation signal greater than 9V?
Yes: GO to PINPOINT TEST D .
No: Refer to the electrical circuit diagrams and check the central junction box power and ground circuits for open circuit, high resistance, repair the circuit as necessary
Using the Jaguar Land Rover Approved Diagnostic Equipment, perform a CAN network integrity test. Refer to the electrical circuit diagrams and check the high speed CAN bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance, repair the circuit as necessary
Using the Jaguar Land Rover Approved Diagnostic Equipment, check the central junction box for related DTCs and refer to the relevant DTC index
- Measure the voltage at the luggage compartment lid latch during actuation at C4PL61-3