Tire Pressure Monitoring System (TPM)
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle.
CAUTION:
When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00.
NOTE:
If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component.
NOTE:
Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer approved diagnostic system).
NOTE:
When performing voltage or resistance tests, always use a digital multimeter (DMM) accurate to three decimal places, and with an up-to-date calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.
NOTE:
Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
NOTE:
If DTCs are recorded and, after performing the pinpoint tests a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.
NOTE:
Where an 'on demand self-test' is referred to, this can be accessed via the 'DTC Monitor' tab on the manufacturers approved diagnostic system.
The table below lists all Diagnostic Trouble Codes (DTCs) that could be logged in the Steering Column Lock Module, for additional Diagnosis and Testing information. For additional information, refer to WHEELS AND TIRES .
| DTC | Description | Possible Cause | Action |
|---|---|---|---|
| C1A56-31 | Left Front Tire Pressure Sensor and Transmitter Assembly-no signal |
|
Refer to PINPOINT TEST F : MISSING, INCOMPATIBLE OR DEFECTIVE RUNNING TIRE LOW PRESSURE SENSOR OR RECEIVER and proceed as directed |
| C1A56-68 | Left Front Tire Pressure Sensor and Transmitter Assembly-event information |
|
No action required. |
| C1A56-91 | Left Front Tire Pressure Sensor and Transmitter Assembly-parametric |
|
Replace defective tire low pressure sensor. Refer to the relevant information. |
| C1A56-93 | Left Front Tire Pressure Sensor and Transmitter Assembly-no operation |
|
Refer to PINPOINT TEST G : LOCALIZATION FAILURE and proceed as directed |
| C1A57-11 | Left Front Initiator-circuit short to ground |
|
Refer to PINPOINT TEST B : LEFT FRONT LOW FREQUENCY INITIATOR CIRCUIT and proceed as directed |
| C1A57-12 | Left Front Initiator-circuit short to battery |
|
Refer to PINPOINT TEST B : LEFT FRONT LOW FREQUENCY INITIATOR CIRCUIT and proceed as directed |
| C1A57-13 | Left Front Initiator-circuit open |
|
Refer to PINPOINT TEST B : LEFT FRONT LOW FREQUENCY INITIATOR CIRCUIT and proceed as directed |
| C1A58-31 | Right Front Tire Pressure Sensor and Transmitter Assembly-no signal |
|
Refer to PINPOINT TEST F : MISSING, INCOMPATIBLE OR DEFECTIVE RUNNING TIRE LOW PRESSURE SENSOR OR RECEIVER and proceed as directed |
| C1A58-68 | Right Front Tire Pressure Sensor and Transmitter Assembly-event information |
|
No action required. |
| C1A58-91 | Right Front Tire Pressure Sensor and Transmitter Assembly-parametric |
|
Replace defective tire low pressure sensor. Refer to the relevant information. |
| C1A58-93 | Right Front Tire Pressure Sensor and Transmitter Assembly-no operation |
|
Refer to PINPOINT TEST G : LOCALIZATION FAILURE and proceed as directed |
| C1A59-11 | Right Front Initiator-circuit short to ground |
|
Refer to PINPOINT TEST C1 and proceed as directed |
| C1A59-12 | Right Front Initiator-circuit short to battery |
|
Refer to PINPOINT TEST C2 and proceed as directed |
| C1A59-13 | Right Front Initiator-circuit open |
|
Refer to PINPOINT TEST C9 and proceed as directed |
| C1A60-31 | Left Rear Tire Pressure Sensor and Transmitter Assembly-no signal |
|
Refer to PINPOINT TEST F : MISSING, INCOMPATIBLE OR DEFECTIVE RUNNING TIRE LOW PRESSURE SENSOR OR RECEIVER and proceed as directed |
| C1A60-68 | Left Rear Tire Pressure Sensor and Transmitter Assembly-event information |
|
No action required. |
| C1A60-91 | Left Rear Tire Pressure Sensor and Transmitter Assembly-parametric |
|
Replace defective tire low pressure sensor, refer to the relevant information. |
| C1A60-93 | Left Rear Tire Pressure Sensor and Transmitter Assembly-no operation |
|
Refer to PINPOINT TEST G : LOCALIZATION FAILURE and proceed as directed |
| C1A61-11 | Left Rear Initiator-circuit short to ground |
|
Refer to PINPOINT TEST D1 and proceed as directed |
| C1A61-12 | Left Rear Initiator-circuit short to battery |
|
Refer to PINPOINT TEST D2 and proceed as directed |
| C1A61-13 | Left Rear Initiator-circuit open |
|
Refer to PINPOINT TEST D2 and proceed as directed |
| C1A62-31 | Right Rear Tire Pressure Sensor and Transmitter Assembly-no signal |
|
Refer to PINPOINT TEST F : MISSING, INCOMPATIBLE OR DEFECTIVE RUNNING TIRE LOW PRESSURE SENSOR OR RECEIVER and proceed as directed |
| C1A62-68 | Right Rear Tire Pressure Sensor and Transmitter Assembly-event information |
|
No action required. |
| C1A62-91 | Right Rear Tire Pressure Sensor and Transmitter Assembly-parametric |
|
Replace defective tire low pressure sensor, refer to the relevant information. |
| C1A62-93 | Right Rear Tire Pressure Sensor and Transmitter Assembly-no operation |
|
Refer to PINPOINT TEST G : LOCALIZATION FAILURE and proceed as directed |
| C1A63-11 | Right Rear Initiator-circuit short to ground |
|
Refer to PINPOINT TEST E1 and proceed as directed |
| C1A63-12 | Right Rear Initiator-circuit short to battery |
|
Refer to PINPOINT TEST E2 and proceed as directed |
| C1A63-13 | Right Rear Initiator-circuit open |
|
Refer to PINPOINT TEST E9 and proceed as directed |
| C1A64-68 | Spare Wheel Tire Pressure Sensor and Transmitter Assembly-event information |
|
No action required. |
| C1A64-91 | Spare Wheel Tire Pressure Sensor and Transmitter Assembly-parametric |
|
Replace defective tire low pressure sensor, refer to the relevant information. |
| C1A64-93 | Spare Wheel Tire Pressure Sensor and Transmitter Assembly-no operation |
|
Refer to PINPOINT TEST H : SPARE TIRE LOW PRESSURE SENSOR NO OPERATION and proceed as directed |
| C1D19-11 | External Receiver Data Line-circuit short to ground |
|
Refer to PINPOINT TEST A : C1D1911 TIRE PRESSURE MONITORING SYSTEM EXTERNAL RECEIVER DATA LINE CIRCUIT SHORT TO GROUND and proceed as directed |
| C1D19-12 | External Receiver Data Line-circuit short to battery |
|
Refer to PINPOINT TEST I : C1D1912 TIRE PRESSURE MONITORING SYSTEM EXTERNAL RECEIVER DATA LINE CIRCUIT SHORT TO POWER and proceed as directed |
| C1D19-87 | External Receiver Data Line-missing message |
|
Refer to PINPOINT TEST J : C1D1987 TIRE PRESSURE MONITORING SYSTEM EXTERNAL RECEIVER DATA LINE MISSING MESSAGE and proceed as directed |
| U0010-88 | Medium Speed CAN Communication Bus-bus off |
|
Carry out CAN network integrity tests. Refer to the electrical wiring diagrams and check CAN network for short, open circuit. |
| U0140-00 | Lost communication with body control module-no sub type information |
|
Refer to the electrical wiring diagrams and check Central Junction Box power and ground supplies for short, open circuit. Carry out CAN network integrity tests. |
| U0142-00 | Lost Communication With Body Control Module ""B"" -no sub type information |
|
Refer to the electrical wiring diagrams and check Rear Junction Box power and ground supplies for short, open circuit. Carry out CAN network integrity tests. |
| U0155-00 | Lost Communications With Instrument Panel Cluster (IPC) Control Module-no sub type information |
|
Refer to the electrical wiring diagrams and check instrument cluster power and ground supplies for short, open circuit. Carry out CAN network integrity tests. |
| U0164-00 | Lost Communication With HVAC Control Module-no sub type information |
|
Refer to the electrical wiring diagrams and check climate control module power and ground supplies for short, open circuit. Carry out CAN network integrity tests. |
| U0300-00 | Internal Control Module Software Incompatibility-no sub type information |
|
Check correct tire pressure monitoring system module is installed to vehicle specification, otherwise suspect the Rear Junction Box. |
| U0415-00 | Invalid Data Received From Anti-Lock Brake System (ABS) Control Module-no subtype information |
|
Check Anti-Lock Braking System control module and Instrument Cluster for related DTCs and refer to the relevant DTC Index. Carry out CAN network integrity tests. |
| U0424-00 | Invalid Data Received From HVAC Control Module-no sub type information |
|
Check climate control module for related DTCs and refer to relevant DTC Index. |
| U1A14-49 | CAN Initialisation Failure-internal electronic failure |
|
Install a new tire pressure monitoring module. Refer to the new module/component installation note at the top of the DTC Index. |
| U3000-55 | Control Module-not configured |
|
Check and amend the car configuration file. |
| U3000-87 | Control Module-missing message |
|
Check the Rear Junction Box for related DTCs and refer to the relevant DTC Index. Carry out CAN network integrity test. |
| U3002-81 | Vehicle Identification Number - invalid serial data received |
|
NOTE:
This DTC indicates that the tire pressure monitoring system module is not the original part installed to the vehicle at the factory/dealer and could have been substituted. Refer to the note above the DTC index about replacing components which may remain under manufacturer warranty. Re-install the original or a new tire pressure monitoring system control module. |