Pinpoint Test G: Localization Failure
- G1: CHECK FOR ADDITIONAL DTCS
- Check for additional DTCs: C1A5711, C1A5712, C1A5713. C1A5911, C1A5912, C1A5913, C1A6111, C1A6112, C1A6113, C1A6311, C1A6312, C1A6313.
Are any of the DTCs listed above also logged?
YES: Refer to the DTC Index and remedial actions.
NO: Go to G 2.
- G2: CHECK FOR ADDITIONAL DTCS
- Check for additional DTCs: C1A5631, C1A5831, C1A6031 or C1A6231
Is a C1A5631, C1A5831, C1A6031 or C1A6231 DTC also logged?
YES: Refer to the DTC Index and remedial actions.
NO: Go to G 3.
- G3: CHECK INITIATOR INSTALLATION
- Check for correct installation of Initiator. Refer to Tire Pressure Monitoring System (TPMS) Front Antenna and Tire Pressure Monitoring System (TPMS) Rear Antenna .
Is the Initiator correctly installed?
YES: Go to G 4.
NO: Rectify as required. Refer to Tire Pressure Monitoring System (TPMS) Front Antenna and Tire Pressure Monitoring System (TPMS) Rear Antenna .
- G4: CHECK FOR SHORT CIRCUIT IN INITIATOR HARNESS
- Locate and remove module blue connector L.
- Measure the resistance across the relevant initiator circuits within the blue connector.
Is the resistance less than 1 Ohm?
YES: A value of less than 1 Ohm indicates a short circuit, rectify the short circuit as required.
NO: Install the correct tire low pressure sensor, of correct frequency, in accordance with that defined in the manufacturer approved diagnostic system new tire low pressure sensor application, to the position identified by the logged DTC. See Tire Low Pressure Sensor .