Pinpoint Test E: Right Rear Low Frequency Initiator Circuit
- E1: CHECK THE INITIATOR CIRCUIT FOR SHORT CIRCUIT TO GROUND
- E2: CHECK THE INITIATOR CIRCUIT FOR SHORT CIRCUIT TO POWER
- E3: CHECK THE INITIATOR CIRCUIT FOR SHORT CIRCUIT TO GROUND
- E4: CHECK THE INITIATOR CIRCUIT FOR SHORT CIRCUIT TO POWER
- E5: CHECK WHETHER THE SHORT CIRCUIT IS IN THE HARNESS OR THE MODULE
- Disconnect the Tire Pressure Monitoring System module connector, CA072.
- Measure the resistance between:
RB009, harness side Battery Pin 2 Negative terminal
Is the resistance less than 10, 000 ohms?
YES: REPAIR the short circuit. This circuit contains intermediate connector, RB001. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.
NO: INSTALL a new Tire Pressure Monitoring System module. Refer to Tire Pressure Monitoring System (TPMS) Module - Vehicles With: Convertible Top and Tire Pressure Monitoring System (TPMS) Module - Vehicles Without: Convertible Top .
- E6: CHECK WHETHER THE SHORT CIRCUIT IS IN THE HARNESS OR THE MODULE
- Disconnect the Tire Pressure Monitoring System module connector, CA072.
- Measure the resistance between:
RB009, harness side Battery Pin 2 Positive terminal
Is the resistance less than 10, 000 ohms?
YES: REPAIR the short circuit. This circuit contains intermediate connector, RB001. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.
NO: INSTALL a new Tire Pressure Monitoring System module. Refer to Tire Pressure Monitoring System (TPMS) Module - Vehicles With: Convertible Top and Tire Pressure Monitoring System (TPMS) Module - Vehicles Without: Convertible Top .
- E7: CHECK WHETHER THE SHORT CIRCUIT IS IN THE HARNESS OR THE MODULE
- Disconnect the Tire Pressure Monitoring System module connector, CA072.
- Measure the resistance between:
RB009, harness side Battery Pin 1 Negative terminal
Is the resistance less than 10, 000 ohms?
YES: REPAIR the short circuit. This circuit contains intermediate connector, RB001. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.
NO: INSTALL a new Tire Pressure Monitoring System module. Refer to Tire Pressure Monitoring System (TPMS) Module - Vehicles With: Convertible Top and Tire Pressure Monitoring System (TPMS) Module - Vehicles Without: Convertible Top .
- E8: CHECK WHETHER THE SHORT CIRCUIT IS IN THE HARNESS OR THE MODULE
- Disconnect the Tire Pressure Monitoring System module connector, CA072.
- Measure the resistance between:
RB009, harness side Battery Pin 1 Positive terminal
Is the resistance less than 10, 000 ohms?
YES: REPAIR the short circuit. This circuit contains intermediate connector, RB001. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.
NO: INSTALL a new Tire Pressure Monitoring System module. Refer to Tire Pressure Monitoring System (TPMS) Module - Vehicles With: Convertible Top and Tire Pressure Monitoring System (TPMS) Module - Vehicles Without: Convertible Top .
- E9: CHECK THE INITIATOR CIRCUIT FOR HIGH RESISTANCE
- Measure the resistance between:
CA072, harness side RB009, harness side Pin 8 Pin 2
Is the resistance greater than 5 ohms?
YES: REPAIR the high resistance circuit. This circuit contains intermediate connector, RB001. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.
NO: Go to E 10.
- Measure the resistance between:
- E10: CHECK THE INITIATOR CIRCUIT FOR HIGH RESISTANCE
- Measure the resistance between:
CA072, harness side RB009, harness side Pin 7 Pin 1
Is the resistance greater than 5 ohms?
YES: REPAIR the high resistance circuit. This circuit contains intermediate connector, RB001. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.
NO: INSTALL a new rear right hand low-frequency initiator. See Tire Pressure Monitoring System (TPMS) Rear Antenna .
- Measure the resistance between: