LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Wheels & Tires) >> Wheels And Tires >> Diagnostic Procedures >> Wheels And Tires >> Pinpoint Tests >> Pinpoint Test B: Left Front Low Frequency Initiator Circuit

Pinpoint Test B: Left Front Low Frequency Initiator Circuit

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. B1: CHECK THE INITIATOR CIRCUIT FOR SHORT CIRCUIT TO GROUND 
    1. Ignition off.
    2. Disconnect the left hand front low-frequency initiator electrical connector, FB013.
      GJ0010292
    3. Measure the resistance between:
      FB013, harness side Battery
      Pin 2 Negative terminal

      4. Is the resistance less than 10, 000 ohms? 

      YES:  Go to B 5.

      NO:  Go to B 2.

  2. B2: CHECK THE INITIATOR CIRCUIT FOR SHORT CIRCUIT TO POWER 
    1. Measure the resistance between:
      FB013, harness side Battery
      Pin 2 Positive terminal

      2. Is the resistance less than 10, 000 ohms? 

      YES:  Go to B 6.

      NO:  Go to B 3.

  3. B3: CHECK THE INITIATOR CIRCUIT FOR SHORT CIRCUIT TO GROUND 
    1. Measure the resistance between:
      FB013, harness side Battery
      Pin 1 Negative terminal

      2. Is the resistance less than 10, 000 ohms? 

      YES:  Go to B 7.

      NO:  Go to B 4.

  4. B4: CHECK THE INITIATOR CIRCUIT FOR SHORT CIRCUIT TO POWER 
    1. Measure the resistance between:
      FB013, harness side Battery
      Pin 1 Positive terminal

      2. Is the resistance less than 10, 000 ohms? 

      YES:  Go to B 8.

      NO:  Go to B 9.

  5. B5: CHECK WHETHER THE SHORT CIRCUIT IS IN THE HARNESS OR THE MODULE 
    1. Disconnect the Tire Pressure Monitoring System module connector, CA072.
      GJ0010293
    2. Measure the resistance between:
      FB013, harness side Battery
      Pin 2 Negative terminal

      3. Is the resistance less than 10, 000 ohms? 

      YES:  REPAIR the short circuit. This circuit contains intermediate connectors, FB001 and FL070. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.

      NO:  INSTALL a new Tire Pressure Monitoring System module. Refer to Tire Pressure Monitoring System (TPMS) Module - Vehicles With: Convertible Top  and Tire Pressure Monitoring System (TPMS) Module - Vehicles Without: Convertible Top .

  6. B6: CHECK WHETHER THE SHORT CIRCUIT IS IN THE HARNESS OR THE MODULE 
    1. Disconnect the Tire Pressure Monitoring System module connector, CA072.
      GJ0010293
    2. Measure the resistance between:
      FB013, harness side Battery
      Pin 2 Positive terminal

      3. Is the resistance less than 10, 000 ohms? 

      YES:  REPAIR the short circuit. This circuit contains intermediate connectors, FB001 and FL070. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.

      NO:  INSTALL a new Tire Pressure Monitoring System module. Refer to Tire Pressure Monitoring System (TPMS) Module - Vehicles With: Convertible Top  and Tire Pressure Monitoring System (TPMS) Module - Vehicles Without: Convertible Top .

  7. B7: CHECK WHETHER THE SHORT CIRCUIT IS IN THE HARNESS OR THE MODULE 
    1. Disconnect the Tire Pressure Monitoring System module connector, CA072.
      GJ0010293
    2. Measure the resistance between:
      FB013, harness side Battery
      Pin 1 Negative terminal

      3. Is the resistance less than 10, 000 ohms? 

      YES:  REPAIR the short circuit. This circuit contains intermediate connectors, FB001 and FL070. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.

      NO:  INSTALL a new Tire Pressure Monitoring System module. Refer to Tire Pressure Monitoring System (TPMS) Module - Vehicles With: Convertible Top  and Tire Pressure Monitoring System (TPMS) Module - Vehicles Without: Convertible Top .

  8. B8: CHECK WHETHER THE SHORT CIRCUIT IS IN THE HARNESS OR THE MODULE 
    1. Disconnect the Tire Pressure Monitoring System module connector, CA072.
      GJ0010293
    2. Measure the resistance between:
      FB013, harness side Battery
      Pin 1 Positive terminal

      3. Is the resistance less than 10, 000 ohms? 

      YES:  REPAIR the short circuit. This circuit contains intermediate connectors, FB001 and FL070. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.

      NO:  INSTALL a new Tire Pressure Monitoring System module. Refer to Tire Pressure Monitoring System (TPMS) Module - Vehicles With: Convertible Top  and Tire Pressure Monitoring System (TPMS) Module - Vehicles Without: Convertible Top .

  9. B9: CHECK THE INITIATOR CIRCUIT FOR HIGH RESISTANCE 
    1. Measure the resistance between:
      CA072, harness side FB013, harness side
      Pin 14 Pin 2

      2. Is the resistance greater than 5 ohms? 

      YES:  REPAIR the high resistance circuit. This circuit contains intermediate connectors, FB001 and FL070. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.

      NO:  Go to B 10.

  10. B10: CHECK THE INITIATOR CIRCUIT FOR HIGH RESISTANCE 
    1. Measure the resistance between:
      CA072, harness side FB013, harness side
      Pin 13 Pin 1

      2. Is the resistance greater than 5 ohms? 

      YES:  REPAIR the high resistance circuit. This circuit contains intermediate connectors, FB001 and FL070. For additional information, refer to the wiring diagram. Clear the DTC and run an On Demand Self Test (ODST) using the manufacturer approved diagnostic system to confirm rectification.

      NO:  INSTALL a new left hand front low-frequency initiator. See Tire Pressure Monitoring System (TPMS) Front Antenna .

scientia non olet · About LEMON Manuals