LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Park Brake Support Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation
  4. Remove the brake caliper and mounting bracket as an assembly. Refer to REAR DISC BRAKE PADS REPLACEMENT (J55) or REAR DISC BRAKE PADS REPLACEMENT (JL9)
  5. Pull down on the front park brake cable and remove the intermediate cable from the connector.
  6. Remove the park brake cable from the brake caliper lever.
  7. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
  8. Remove the brake rotor. Refer to REAR BRAKE ROTOR REPLACEMENT (J55) or REAR BRAKE ROTOR REPLACEMENT (JL9)
  9. Remove the hub and bearing assembly. Refer to WHEEL BEARING/HUB REPLACEMENT - REAR (FE7) or WHEEL BEARING/HUB REPLACEMENT - REAR (FE1, FE3)
  10. Remove the park brake shoe. Refer to Park Brake Shoe Replacement 
    11. Fig 1: Identifying Backing Plate Bolts
    GM370684Courtesy of GENERAL MOTORS CORP.
  11. Remove the support bolts.
  12. Remove the support.
scientia non olet · About LEMON Manuals