LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Park Brake Shoe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and the wheel. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: View Of Intermediate Park Brake Cable & Front Park Brake Cable Connector
    GM492729Courtesy of GENERAL MOTORS CORP.
  3. Pull down on the front park brake cable (3) and remove the front park brake cable (3) from the connector (1).
  4. Remove the park brake cable from the brake caliper lever.
  5. Remove the rear brake caliper. Refer to Rear Brake Caliper Replacement (J55) or Rear Brake Caliper Replacement (JL9) .
  6. Remove the rear brake caliper bracket. Refer to Rear Brake Caliper Bracket Replacement (J55) or Rear Brake Caliper Bracket Replacement (JL9) .
  7. Remove the brake rotor. Refer to Rear Brake Rotor Replacement (J55) or Rear Brake Rotor Replacement (JL9) .
    8. Fig 2: Locating Adjustment Screw, Park Brake Shoe & Retaining Spring
    GM370485Courtesy of GENERAL MOTORS CORP.
  8. Turn the adjustment screw (1) to the fully home position in the notched adjustment nut.
  9. Remove the park brake shoe assembly by sliding the shoe (2) towards the retaining spring (3) until the shoe disengages from the spring.
scientia non olet · About LEMON Manuals