LEMON Manuals: Even more car manuals for everyone
Home >> Isuzu >> 2007 >> i-290 LS, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Parking Brake System) >> Repair Instructions >> Park Brake Shoe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the debris and the dust from the park brake components using a clean shop towel.
    2. Fig 1: Locating Adjustment Screw, Park Brake Shoe & Retaining Spring
    GM370485Courtesy of GENERAL MOTORS CORP.
  2. Align the slots in both the adjusting screw and tappet to be parallel with the backing plate face.
  3. Position the park brake shoe (2) on the inboard side of the actuator (1).
  4. Slide the parking brake shoe into position and seat into the retaining spring (3).
  5. Inspect the shoe assembly position. The shoe must be central on the backing plate with both tips located in the slots.
  6. Adjust the park brake shoe. Refer to Park Brake Adjustment (J55) .
  7. Install the brake rotor. Refer to Rear Brake Rotor Replacement (J55) or Rear Brake Rotor Replacement (JL9) .
  8. Install the rear brake caliper bracket. Refer to Rear Brake Caliper Bracket Replacement (J55) or Rear Brake Caliper Bracket Replacement (JL9) .
  9. Install the rear brake caliper. Refer to Rear Brake Caliper Replacement (J55) or Rear Brake Caliper Replacement (JL9) .
  10. Install the park brake cable to the park brake lever.
    11. Fig 2: View Of Intermediate Park Brake Cable & Front Park Brake Cable Connector
    GM492729Courtesy of GENERAL MOTORS CORP.
  11. Connect the front park brake cable (3) to the connector (1).
  12. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  13. Lower the vehicle.
scientia non olet · About LEMON Manuals