Work Procedure

CONSULT Configuration Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification (Type ID). Refer to Work Procedure (Before Replacement) .

NOTE: If "Before Replace ECU" of "Read / Write Configuration" can not be used, use the "Manual Configuration" after replacing 3CH CAN gateway.

>>

GO TO 2.

Replace 3CH CAN gateway. Refer to Removal and Installation .

>>

GO TO 3.

CONSULT Configuration Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification (Type ID). Refer to Work Procedure (After Replacement) .

>>

GO TO 4.

1. Erase all ECU self-diagnosis results using CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.

>>

WORK END