Work Procedure (Before Replacement)

1. Use EPC (service parts catalogue) to search 3CH CAN gateway of the applicable vehicle and find "Type ID".
2. Print out "Type ID".

>>

GO TO 2.

CONSULT Configuration

1. Select "Before Replace ECU" of "Read/Write Configuration".
2. Check that "Type ID" is displayed on the CONSULT screen.

Is "Type ID" displayed?

>>

GO TO 3.

>>

WORK END (Use the "Manual Configuration" after replacing 3CH CAN gateway.)

CONSULT Configuration Compare a "Type ID" displayed on the CONSULT screen with the one searched by using EPC (service parts catalogue) to check that these "Type ID" agree with each other.

NOTE: For the "Type ID" searched by using EPC (service parts catalog), use the last five digits of the "Type ID".

>>

GO TO 4.

CONSULT Configuration Save "Type ID" on CONSULT.

>>

WORK END