Work Procedure (After Replacement)

CAUTION:

Use "Manual Configuration" only when "TYPE ID" of CAN gateway cannot be read.
If an error occurs during configuration, start over from the beginning.

CHECKING THAT "TYPE ID" IS SAVED ON CONSULT
Check that "TYPE ID" is saved on CONSULT.

Is "TYPE ID" saved on CONSULT '

>>

GO TO 2.

>>

GO TO 3.
WRITING (AUTOMATIC WRITING)
CONSULT Configuration
1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
2. Select the "Type ID" agreeing with the one stored on CONSULT and the one searched by using EPC (service parts catalogue).
  NOTE: For the "Type ID" searched by using EPC (service parts catalog), use the last five digits of the "Type ID".
3. Write the "Type ID" into the 3CH CAN gateway.
>>

GO TO 4.
WRITING (MANUAL WRITING)
CONSULT Configuration
1. Select "Manual Configuration".
2. Select the "Type ID" agreeing with the one stored on CONSULT and the one searched by using EPC (service parts catalogue).
  NOTE: For the "Type ID" searched by using EPC (service parts catalog), use the last five digits of the "Type ID".
3. Write the "Type ID" into the 3CH CAN gateway.
>>

GO TO 4.
VERIFYING TYPE ID (2)
Compare "Type ID" written into the 3CH CAN gateway with the one searched by using EPC (service parts catalogue) to check that these "Type ID" agree with each other.

NOTE: For the "Type ID" searched by using EPC (service parts catalog), use the last five digits of the "Type ID".

>>

GO TO 5.
PERFORM SELF-DIAGNOSIS RESULT
1. Erase "self-diagnosis result" with CONSULT.
2. Turn the ignition switch OFF.
3. Turn the ignition switch ON and wait for 2 seconds or more.
4. Perform "All DTC reading" with CONSULT.
Is displayed any DTC for CAN communication circuit?

>>

Repair the CAN communication circuit.

>>

WORK END