LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> G37 IPL, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 62 (Front Suspension (AWD) -- G37 Coupe) >> Unit Removal And Installation >> Front Suspension Member >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove tire with power tool.
  2. Remove under cover with power tool.
  3. Remove front cross bar.
  4. Separate steering gear assembly and lower joint. Refer to "WITHOUT 4WAS : EXPLODED VIEW ".
  5. Remove steering outer socket from steering knuckle. Refer to "AWD : EXPLODED VIEW ".
  6. Remove wheel sensor from steering knuckle. Refer to "FRONT SENSOR ROTOR : EXPLODED VIEW ".
  7. Remove shock absorber. Refer to "EXPLODED VIEW ".
  8. Remove front stabilizer. Refer to "EXPLODED VIEW ".
  9. Install engine slinger, and then hoist engine. Refer to "AWD : REMOVAL AND INSTALLATION ".
  10. Remove transverse link from front suspension member with power tool. Refer to "EXPLODED VIEW ".
  11. Remove steering hydraulic piping bracket and steering gear from front suspension member. Refer to "AWD : EXPLODED VIEW ".
  12. Set suitable jack front suspension member.
  13. Remove mounting nuts between engine mounting insulator and from suspension member. Refer to "AWD : EXPLODED VIEW ".
  14. Remove mounting bolts and nuts of front suspension member with power tool.
  15. Gradually lower jack to remove front suspension assembly from vehicle.
scientia non olet · About LEMON Manuals